TRUEFREE T2 Wireless Earbuds User Guide

June 9, 2024
TRUEFREE

TRUEFREE T2 Wireless Earbuds

Pairing

TRUEFREE-T2-Wireless-Earbuds-fig-1

  1. Open the charging case cover, and the left and right earphones will automatically turn on and enter the mutual pairing state., When the light on one earphone flashes red and blue alternately and fhe other earphones says in blue, fhe fwo earphones are successfully paired, and they enter the pairing mode.
  2. Turn on your device’s Bluetooth and select TRUEFREE T2 from the Bluetooth isT fo complete fhe pairing.

Reset

  1. Place the earphones back into the charging Case, and make sure they are correctly placed.
  2. With the charging case lid open, press and hold the button on the charging case for 10 seconds until the lights on the earphones flash red and blue alfernately twice, the resef is Complete.
  3. Close the charging case lid and re-open it, the earphones are activated.

Wearing

  1. Identify the left earphone and the right earphone.
  2. Adjust the earphones to fif your ears.

Product Diagram

TRUEFREE-T2-Wireless-Earbuds-fig-4

Touch Control

TRUEFREE-T2-Wireless-Earbuds-fig-5

Q&A

What does the indicator light of the charging case display?

  1. The battery life of the charging case:TRUEFREE-T2-Wireless-Earbuds-fig-6
  2. Charging status of the charging case:TRUEFREE-T2-Wireless-Earbuds-fig-7

How to charge the charging case?

  1. Connect the charging case fo a Type-c charger. (The current does not exceed A).
  2. If the earphones stay idle for an extended period, charge them at least every three months to prevent the bafery from being damaged

3: Why are the earphones still connected to the phone when they are put back to the charging case and the case lid is closed?

  1. Check whether the charging case has battery power. If it has run out of battery, closing if will nof disconnect the earphones from the device,
  2. Make Sure the earphones are properly placed in the charging case and the charging confacts on the earphones and charging case are all clean. Please use a soff clofn and a bit of alcohol fo clean fhe confact points on fne earphones and the charging case,

IC STATEMENT

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device

FCC STATEMENT

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures:

  • Reorient the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.

MANUFACTURER
Shenzhen Ginto E-Commerce Co., Limited

EC REP

  • Company: Qing UG(haftungsbeschränkt)
  • Address: Undinestr. 7, 12203 Berlin Germany

UK REP

TANMET INTL BUSINESS LTD
9 Pantygraigwen Road, Pontypridd, Mid Glamorgan, CF37 2RR,UK tanmetbiz@outlook.com

FCC ID: 2A5BOHOYO02 IC ID: 28277-HOYO03 MADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals