GRACO Turn2Me Convertible Car Seat User Manual
- June 9, 2024
- Graco
Table of Contents
Convertible Car Seat
User Manual
Turn2Me Convertible Car Seat
IMPORTANT! KEEP FOR FUTURE REFERENCE.
|
---|---
|
|
|
1. Head Support
2. Seat Pad
3. Buckle
4. Adjustment Webbing
5. Recline Adjustment Button
6. Load Leg
7. Load Leg Adjustment Button
8. Load Leg Indicator| 9. Rotating Button
10. Shoulder Strap
11. Infant Insert
12. Head Support Adjustment Lever
13. ISOFIX Adjuster Button
14. ISOFIX Connector
15. ISOFIX Guides
16. Instruction Manual Storage
---|---
IMPORTANT
READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE
REFERENCE. YOUR CHILD’S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE
INSTRUCTIONS.
WARNING:
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.
NO child restraint can guarantee full protection from injury in an accident.
However, proper use of this child restraint will reduce the risk of serious
injury or death to your child.
The child should weight under 18kg (approximately 4 years old or under).
Any support-leg should be in contact with the vehicle floor and any straps
restraining the child should be adjusted to the child’s body. The straps
should not be twisted.
DO NOT use forward facing mode before the child’s weight exceeds 9kg. Keep
your child rearward facing as long as possible as rearward facing is the
safest position.
DO NOT install or use this child restraint without following the instructions
and warnings in this manual or you may put your child at serious risk of
injury or death.
DO NOT make any modifications to this child restraint or use it along with
component parts from other manufacturers.
DO NOT use this child restraint if it is damaged or has missing parts.
DO NOT have your child in large/oversized clothes when using this enhanced
child restraint in baby or toddler mode, because this may prevent your child
from being properly and securely fastened by the shoulder harness straps and
the crotch strap between the thighs.
When using this child restraint in rear facing or forward facing mode, the
harness must be used correctly, and make sure the lap belt is not above the
child’s pelvis portion.
DO NOT leave this child restraint unsecured in your vehicle because an
unsecured child restraint can be thrown around and may injure occupants in a
sharp turn, sudden
stop, or collision. Remove it if not in regular use.
NEVER leave your child unattended with this child restraint.
Please do not use this child restraint if the child restraint has dropped from
a significant height, hit the ground at a considerable speed, or has visible
signs of damage. We are not responsible to replace if the child restraint has
been damaged under these abnormal conditions. A new child restraint will need
to be purchased when any of the aforementioned conditions occurs.
NEVER install this child restraint on any vehicle seat equipped with safety
airbags when used in rear facing mode.
NEVER use a second-hand child restraint or a child restraint whose history you
do not know because they may have structural damage that endangers your
child’s safety.
Please keep this child restraint away from sunlight﹐ otherwise it may be too
hot for the child’s skin.
DO NOT use this child restraint as a regular chair as it tends to fall down
and could injure the child.
DO NOT use this child restraint without the soft goods.
The soft goods should not be replaced with any besides the ones recommended by
the manufacturer, because the soft goods constitute an integral part of the
child restraint performance.
DO NOT put anything other than the recommended soft goods in this child
restraint.
DO NOT put unsecured items in the vehicle because they can be thrown around
and may injure occupants in a sharp turn, sudden stop, or collision. Do not
place other items on top of the child restraint if it is in the car boot to
prevent damage.
Do not allow the child restraint harness or buckles to become trapped or
caught in the vehicle seat or door.
DO NOT continue to use this child restraint after it has suffered any violent
crash. Replace immediately as there may be invisible structural damage from
the crash.
Remove this child restraint from the vehicle seat when it is not in use for a
long period of time.
To avoid suffocation﹐ remove plastic bag and packaging materials before using
this product. The plastic bag and packaging materials should then be kept away
from babies and children.
Consult the retailer for issues concerning maintenance, repair and part
replacement.
Do not place any objects in the load leg area in front of your base.
DO NOT carry this child restraint with a child in it.
Frequently check the ISOFIX guides for dirt and clean them if necessary.
Reliability can be effected by ingress of dirt, dust, food particles etc.
DO NOT use any load bearing contact points other than those described in the
instructions and marked on the child restraint.
Correct Installation is only permitted by use of the ISOFIX connectors.
DO NOT install this child restraint under the following conditions:
- Vehicle seats with lap belt or 3-point-belt.
- Vehicle seats facing sideways or rearward with respect to the running direction of the vehicle.
- Vehicle seats movable during installation.
Product Information
- According to the UN ECE R44.04 Regulation, the child restraint is a Semi-Universal ISOFIX Class A, C, D Child Restraint.
- If in doubt, please consult the child restraint manufacturer or the retailer.
For Installation with ISOFIX System
This is an ISOFIX CHILD RESTRAINT SYSTEM. It is approved to UN ECE regulation
44, 04 series of amendments for general use in vehicles fitted with ISOFIX
anchorages systems.
It will fit vehicles with positions approved as ISOFIX positions (as detailed
in the vehicle handbook), depending on the category of the child restraint and
of the fixture. If in doubt, consult either the infant child restraint
manufacturer or vehicle manufacturer.
The ISOFIX size class for which this device is intended is A, C, D.
Suitable for Child weighing under 18kg
Mass Group Group 0+/1
Materials Plastics, metal, fabrics
Patent No. Patents pending
Concerns on Installation
See images 1 – 3
1. DO NOT install this child restraint on vehicle seats that face
sideways or rearward with respect to the moving direction of the vehicle.
It is recommended to install this child restraint on the rear vehicle seat.
DO NOT install this child restraint on vehicle seats movable during
installation.
2. DO NOT place rear-facing child restraint on front seat with air bag,
because death or serious injury may occur. Please reference vehicle owner’ s
manual for more information.
3. This child restraint is suitable for vehicle seats with ISOFIX anchor
points.
Installation with base
See images 4 – 13
4. Fit the ISOFIX guides with the ISOFIX anchor points.
The ISOFIX guides can protect the surface of the vehicle seat from being torn.
They can also guide the ISOFIX connectors.
5. After placing the base on the vehicle seat, pull the load leg downward
to floor.
6. There are 10 adjustable positions for ISOFIX. Press the ISOFIX
adjuster button to extend the ISOFIX.
7. Make sure that both ISOFIX connectors are securely attached to their
ISOFIX anchor points. The colors of the indicators on both ISOFIX connectors
should be completely green.
If a tighter install or increased cabin space is required, then press the
ISOFIX adjuster button 6 – 1 and push to adjust. 7
8. After attaching the ISOFIX, pull the load leg downward to floor.
9. When the load leg indicator shows green, the load leg is installed
correctly. Squeeze the load leg releasing button, then adjust the load leg
length.
The load leg has 12 positions. When the load leg indicator shows red this
means the load leg is in the wrong position.
Make sure the load leg is in full contact with the vehicle floor pan. Red
means it is installed incorrectly.
10. Check to make sure the base is securely installed by pulling on both
ISOFIX connectors.
The ISOFIX connectors must be attached and locked onto the ISOFIX anchor
points.
The load leg must be installed correctly with green indicator.
Please refer to rear facing mode and recline positions mode in section to use
the child restraint.
11. To remove from the vehicle press the ISOFIX adjuster button and pull
the base back from the seat.
12. Then press and release the connectors from the vehicle’s ISOFIX.
13. To prevent damage during transit﹐ press the ISOFIX adjuster button
and fold the connector completely.
Recline Adjustment
See image 14
14. Squeeze the recline adjustment button, to adjust the child
restraint to the proper position.
Please recheck the load leg position after reclining.
There are 5 recline positions for rear facing mode and 5 recline
positions for forward facing mode.
Height Adjustment
for Head Support and Shoulder Harnesses
See images 15 – 17
Please adjust the head support and check if the shoulder harnesses are at
the correct height according to 15.
When used rear facing﹐ the shoulder harness height must be even with child’s
shoulders. When used forward facing﹐ the shoulder harness height must be even
with child’s shoulders.
16. Squeeze the head support adjustment lever, meanwhile pull up or push
down on the head support until it snaps into one of the 6 positions. 17
Using in the Rear Facing Mode
(Rearward Facing Mode/for Child under 18kg /infant – 4 years old)
See images 18 – 27
Please install the child restraint on the rear vehicle seat﹐ and then put the
child in the child restraint. 4 – 9
18. Press the ISOFIX adjuster button and pull the base back from the vehicle
seat.
19. Press the rotating button to rotate for easier side loading/unloading
of the child﹐ then rotate back to desired direction.
20. If a tighter install or increased cabin space is required, then press
the ISOFIX adjuster button and push to adjust.
21. The ISOFIX connectors must be attached and locked onto the ISOFIX
anchor points.
The load leg must be installed correctly with green indicator.
After the child is placed into the seat, check whether the Shoulder Harness
Straps are at proper height.
22. Press the webbing adjustment button, while pulling out the shoulder
harnesses to the proper length.
23. Unlock the buckle of the harnesses by pressing the red button.
24. Fix the buckles on the both sides of seat to make placing the child
in rear facing mode more convenient.
25. Use Infant insert is for children’s protection. We recommend using
the full infant insert while the baby is 0-6 months or until they outgrow the
insert. The infant insert increases side impact protection. Detach the snaps
on the head support to remove the head portion of the insert. Remove the head
support portion of the infant insert when the child’s head no longer fits
comfortably. Remove the body portion of the infant insert when the infant’s
shoulders no longer fit comfortably.
Remove the infant insert cushion by
detaching the snaps to allow more space when the infant does not fit
comfortably.
The cushion can be used separately without being attached to the insert to
bolster the infant’s back for more comfort.
Place the child into the child restraint and pass both arms through the
harnesses.
After the child is seated. recheck whether the shoulder harnesses are at the
proper height.
26 Engage the buckle.
27 Pull down the adjustment webbing and adjust it to the proper length to
make sure your child is properly secured.
Make sure the space between the child and the Shoulder Harness Straps is about
the thickness of one hand.
If steps **22 23 24** are taken when arriving at your destination whilst
removing the child﹐ then the harness will be positioned so that it is out of
the way and ready for loading upon your return to the vehicle.
Using in the Forward Facing Mode
(Forward Facing Mode/for Child between 9-18kg / 1-4 years old)
See images 28 – 35
Please install the child restraint on the vehicle seat ,and then put the child
in the child restraint. 4 – 9
28 Press the ISOFIX adjuster button and pull the base back from the
vehicle seat.
29 Press the rotating button to rotate for easier side loading/ unloading
of the child﹐ then rotate forwards to desired direction.
30 If a tighter install or increased cabin space is required﹐ then press
the ISOFIX adjuster button and push to adjust.
31 The ISOFIX connectors must be attached and locked onto the ISOFIX
anchor points.
The load leg must be installed correctly with green indicator.
After the child is placed into the seat﹐ check whether the Shoulder Harness
Straps are at proper height.
32 Press the webbing adjustment button, while pulling out the shoulder
harnesses to the proper length.
33 Unlock the buckle of the harnesses by pressing the red button.
34 Fix the buckles on the both sides of seat to make placing the child in
forward facing mode more convenient.
When installing the child restraint in the forward facing mode, do not use the
infant insert.
Place the child into the child restraint and pass both arms through the
harnesses. Engage the buckle.
After the child is seated﹐ recheck whether the shoulder harnessesare at the
proper height.
35 Pull down the adjustment webbing and adjust it to the proper length to
make sure your child is properly secured.
Make sure the space between the child and the Shoulder Harness
Straps is about the thickness of one hand.
If steps **32 33 34** are taken when arriving at your destination whilst
removing the child﹐ then the harness will be positioned so that it is out of
the way and ready for loading upon your return to the vehicle.
Detach Soft Goods
See images 36 – 43
36 Press the red button to disengage the buckle.
Follow steps 37 – 43 to detach soft goods.
To re-attach the soft goods please repeat the above steps in the reverse step.
Care and Maintenance
After removing the wedge from the insert﹐please store it somewhere that the
child cannot access it.
Please wash the seat cover and inner padding with cold water under 30°C.
Do not iron the soft goods.
Do not bleach or dry clean the soft goods.
Do not use undiluted detergents﹐ gasoline or other organic solvent to wash the
child restraint. It may cause damage to the child restraint.
Do not wring out the seat cover and inner padding to dry. It may leave the
seat cover and inner padding with wrinkles.
Please hang dry the seat cover and inner padding in the shade.
Please remove the child restraint from the vehicle seat if not in use for a
long period of time. Put the child restraint in a cool﹐ dry place where your
child cannot access it.
Do not tamper with the harness connectors during cleaning.
gracobaby.eu
www.gracobaby.pl
Allison Baby UK Ltd
Venture Point, Towers Business Park Rugeley,
Staffordshire, WS15 1UZ
Customer Service
gracobaby.eu
www.gracobaby.pl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>