timberk T-KSI02 Steam Iron Instruction Manual

June 9, 2024
TIMBERK

T-KSI02 Steam Iron
Instruction Manual

T-KSI02 Steam Iron

IM2022
Dear customer!
We thank you for your wise choice and for a purchase of a steam iron. It will serve you for a long time.

IMPORTANT INFORMATION

Please, read this manual before using the device. This manual contains important information regarding your safety, as well as recommendations concerning the correct use and maintenance of this appliance. Keep this manual together with a warranty card, cash register receipt and, if possible, carton and packaging material. This instruction manual describes different types of this device. The device you purchased may differ slightly from the description in the manual, which does not affect the methods of use and operation. The manufacturer reserves the right to make minor changes to the device without additional notice which is not fundamentally affect its safety, performance and functionality. There may be some misprints in text and digital notations in the present manual.
IMPORTANT! Important safeguards and descriptions contained in this manual do not include all possible situations that you may experience using the device. The manufacturer is not responsible for damage of the appliance or its parts during transportation, as a result of incorrect installation or voltage fluctuations, as well as when any part of the appliance has been changed or modified.
NOTE There is a label on the device which has all the necessary technical data and other useful information about the device. Use the appliance only for the purpose specified in this manual.

SAFEGUARDS

  1. Please read the instruction manual before use and save it for future references.
  2. Before the first switching on check that voltage indicated on the rating label corresponds to the mains voltage in your home.
  3. For home use only. Do not use for industrial purposes. Use the steam iron only for its intended use.
  4. Do not use outdoors or in damp area.
  5. Never pull the cord while disconnecting from the power outlet; instead, grasp the plug only and pull to disconnect.
  6. Do not allow the cord to touch sharp edges and hot surfaces.
  7. Always unplug the steam iron from the power supply when filling with water or emptying and when not in use.
  8. To prevent risk of electric shock and fire, do not immerse the appliance in water or any other liquids. If it has happened DO NOT TOUCH the appliance, unplug it immediately and check in a service center.
  9. In case of power cord is damaged, its replacement should be done by the manufacture or service department or the other high-skill person to avoid any danger.
  10. The appliance is not intended for use for physically, sensory or mental disabled person (including children) or for person with lack of life experience or knowledge, if only they are under supervision or have been instructed about the use of the unit by responsible person.
  11. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. leaning and user maintenance shall not be made by children without supervision.
  12. Children must be under control in order not to be allowed to play with the appliance.
  13. Keep the iron and its cord out of reach of children less than 8 years of age when it is energized or cooling down.
  14. Do not attempt to repair, adjust or replace any parts of the appliance. Check and repair the malfunctioning appliance in the nearest service center only.
  15. Do not leave the iron unattended while hot or connected or on an ironing board.
  16. If ironing is interrupted, stand the iron on heel rest only, do not place the steam iron on metal or rough surfaces.
  17. Iron should be used and stored on a flat, stable surface.
  18. Iron should not be used if it is dropped, if there visible signs of damage or if it leaks.
  19. When placing the iron on its stand, ensure that the surface on which the stand is placed is stable.
  20. CAUTION: To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
  21. If the product has been exposed to temperatures below 0ºC for some time it should be kept at room temperature for at least 2 hours before turning it on.
  22. Do not use accessories that are not included in the delivery set.

APPOINTMENT OF THE DEVICE

The device is designed for ironing clothes and other fabric products.

SPECIFICATIONS

Specifications of the device are shown in Table 1.
Table 1

Parameter Units Technical parameters
Rated power consumption W 2000-2400
Power supply V/Hz 220-240-150
Steam rate g/min 45
Burst of steam g/min 200
Water tank ml 480
Net weight kg 1.
Dimensions mm 317x135x155

Parameter Rated power consumption Power supply Steam rate Burst of steam Water tank Net weight Dimensions

DEVICE DESCRIPTION

1. Spray nozzle
2. Water filling inlet
3. Steam Blow Button
4. Spray button
5. Variable steam control
6. Handle
7. Swiveling cord protector| 8. Heel rest
9. Indicator light
10. Half-transparent water tank
11. Temperature control dial
12. Soleplate «Ceramic Micro»
13. Beaker
---|---

timberk T-KSI02 Steam Iron fig 1Fig. 1
The appearance of the device may differ from the images in the manual

DELIVERY SET

  1. Steam iron – 1 pc.
  2. Cup – 1 pc.
  3. Instruction manual – 1 pc.
  4. Warranty card – 1 pc.
  5. Packing – 1 pc.

IRON SOLEPLATE

The “Ceramic Micro” soleplate is coated with the professional metal-ceramic coating.The coating is characterized by an enhanced level of strength, glide and 100% resistance to burning.

BEFORE THE FIRST USE

Some parts of the steam iron have been slightly greased and as a result the iron may slightly smoke when switched on for the first time. After a short time this will cease.

HOW TO USE

SETTING TEMPERATURE

  • Always check whether a label with ironing instructions is attached to an article to be ironed. Follow these instructions in all cases.
  • Turn the temperature control dial round to set the appropriate temperature indicated in ironing instructions or on fabric label.
LABEL TYPE OF TEXTILE
Do not iron this article
Synthetics, Nylon, Acrylics, Polyester, Rayon
•• Wool, Silk
••• Cotton, Linen
  Maximum temperature (Steam)
  • Insert the mains plug into the wall socket. The indicator light will turn on.
  • When the indicator light goes out you may start ironing
  • If you set the temperature control to lower setting after ironing at a high temperature, it is not recommended to iron before the pilot light switches on again.

WATER TANK FILLING

  • Unplug the iron before filling the water tank.
  • Hold the steam iron in horizontal position.
  • Slowly pour water through the water inlet.
  • Do not fill higher than mark on the water tank, in order to avoid water spilling.
  • The opening which is used for pouring water should be closed when the iron is in use.
  • Always unplug the iron from the power socket when refilling the water reservoir.

NOTE:

  • Your steam iron is designed to use tap water. However, if the water is very hard, it is advisable to use distilled water.
  • Do not use chemically de-limed or perfumed water.
  • If you have too hard water, it is advisable to use only distilled or demineralized water.
  • The water tank should be emptied after each use.

ATTENTION : After draining the water from the cooled iron, place it vertically (on the heel) and turn it on for 2 minutes in the maximum heat mode, then unplug the iron from the mains.
SPRAYING

  • As long as there is enough water in the water tank, you may use the spray button at any temperature setting during steam or dry ironing.
  • Press the spray button several times to activate the pump while you are ironing.

STEAM IRONING

  • With the unit unplugged, fill the steam iron with water.
  • Stand the steam iron on its heel rest in an upright position on an iron-safe surface and plug in.
  • Set the temperature control dial to the “··” or “···” position.
  • When the indicator light is off, the steam iron has reached desired temperature.
  • Set the variable steam control to the desired position.
  • When finished, turn the temperature dial counterclockwise to the minimum position and unplug the appliance from the power supply.

CAUTION: Avoid coming in contact with ejected steam.
DRY IRONING

  • The steam iron can be used on the dry setting with or without water in the water tank, however it is best to avoid having the water tank full while dry ironing.
  • Turn the variable steam control to the minimum position .

CAUTION: If the steam iron has been used for a long time, it is hot and there is no water. Do not refill it with water until the steam iron cools down.
BURST OF STEAM
The burst of steam feature provides additional steam for removing stubborn wrinkles. Press the powerful steam button to release the burst of steam.
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button pressed for more than 5 seconds. For the best steam quality, do not use more than three successive bursts each time, because the iron will cool.
VERTICAL STEAM

  • Ensure that there is enough water in the water tank.
  • Stand the steam iron on its heel rest on an iron-safe surface and plug it.
  • Set the temperature control dial and variable steam control to their maximum positions.
  • Hold the iron vertically and press the steam burst button, an intense steam will be ejected from the soleplate.

WHEN YOU FINISHED IRONING
Set the temperature dial to the minimum position. Remove the mains plug from the wall socket.

CARE AND CLEANING

  • Before cleaning the steam iron ensure it is unplugged from the power supply and has completely cooled down.
  • Do not use abrasive cleaners.

SELF-CLEANING

  • Fill water reservoir up to the maximum level and then close it.
  • Set the temperature control to its maximum position.
  • Insert the main plug into the wall socket.
  • Allow the iron to heat up until the indicator light goes out.
  • Holding the iron horizontally over the sink then change the steam control to the maximum position .
  • Boiling water and steam will be ejected from the holes in soleplate with Impurities washed out.
  • Rock the iron forwards and backwards during this operation.
  • Repeat self-cleaning if you notice that much impurity has been washed out.
  • Move the iron over an old (preferably) piece of cloth.
  • This to ensure that the soleplate will be dry during storage.

STORAGE

Unplug the appliance from the power supply, empty the water tank (do it after each use) and allow the steam iron to cool down completely.
Wrap the cord around the heel rest. To protect the soleplate, place the steam iron in an upright position on its heel rest.

UTILIZATION RULES

The symbol on the unit, packing materials and/or documentations means used electrical and electronic units should not be toss in the garbage with ordinary household garbage. These units should be pass to special receiving point.
For additional information about actual system of the garbage collection address to the local authority.
Valid utilization will help to save valuable resources and avoid negative work on the public health and environment which happens with incorrect using garbage.
After the lifetime of the device expires, it should be recycled in compliance with the laws, rules and methods in region of recycling. Detailed information about the recycling of the device, you can receive from a representative of the local authorities, after providing full information about the device. The manufacturer and authorized organization of the manufacturer do not carry responsibility for the fulfillment by the Buyer of the requirements of legislation on utilization and methods of utilization of the device selected by the Buyer. The lifetime of the device is indicated in the warranty card. Warranty period for the device and warranty terms are specified in the warranty card. The warranty card is an integral part of the documentation supplied with this unit. If there is no warranty card in the delivery set, ask for it from the Seller. The warranty card provided by the Seller must conform to the manufacturer’s form.
The manufacturer and the authorized organization of the manufacturer remove responsibility for any possible harm which can be caused to people, animals or property directly or indirectly, if this harm occurred as a result of noncompliance with the rules and operating conditions, installation of the device, intentional or reckless actions of the user- and / or third parties, as well as in situations caused by natural and / or anthropogenic accidents.

www.timberk.ru

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals