PCNA Stark 2.0 Bluetooth Speaker User Manual
- June 9, 2024
- PCNA
Table of Contents
Functions:
- Power Button
- Play/Pause, Answer/End call.
- Vol-/Previous Track
- Vol +/Next Track
- Type-C charging port
- Charging and Bluetooth LED indicator
- Microphone
Tech Specifications:
Pairing name: Stark 2.0 Speaker
Bluetooth version: 5.3
Charging time : about 3 hours
Playing time in max volume:about 4-4.5 hours
How to use speaker:
1. Bluetooth Setup:
- Press and hold power button to turn ON the speaker ,LED indicator flashes quickly in Blue when in pairing mode.
- Turn on the Bluetooth function on mobile device, Select” Stark 2.0 Speaker” pairing name.
- LED will turn solid BLUE if successfully paired, the LED will flash in BLUE slowly when playing.
- Speaker will automatically pair if the mobile device has been paired before.
- If disconnect Bluetooth after 5 mins, the speaker Bluetooth will auto shut off.
- Press and hold power button 3 seconds to power off the speaker.
2. Playing Music:
When connected to a Bluetooth device, playback can be controlled with your connected device, or with the speaker controls listed below.
- Short press “ ” button to pause music. A second short press will resume playing music again.
- Long press “-” button, the speaker will play the previous track. Short press to reduce speaker volume.
- Long press “+” button, the speaker will play the next track. Short press to increase speaker volume.
3. Call Function:
Phone functions can be controlled through the speaker when Bluetooth-paired to a phone with the commands below.
- Short press “ ” button to answer a incoming call, press again to end call.
- Long press “ ” button to reject the call.
4. Charging the Speaker
- Plug the small connector of the included charging cable into the charging port on the side of the speaker. Plug the large connector into a USB power source, such as a 5V/2A USB wall adapter (not included).
- The charging LED indicator will turn RED while charging and turn OFF when fully charged.
- When the speaker is low on power, a tone “dududu..” will be heard indicating that it needs to be recharged.
FCC Statement:
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>