ACONIC AC-STS-R Slim True Wireless Earbuds User Manual
- June 9, 2024
- ACONIC
Table of Contents
ACONIC AC-STS-R Slim True Wireless Earbuds User Manual
Pairing Instructions
-
To start the pairing process turn on the Bluetooth TM device
-
Open the charging case and remove the earbuds. Earbuds are turned on automatically. (When earbuds are turned off, press the multi-function button on one earbud for 2 seconds to turn on.)
-
Go to your BluetoothTM settings on your device and click on “Aconic Slim TWS” When the earbuds are paired successfully you will hear a voice say, “connected.” Please note: make sure the two devices are within 30 feet in order for them to be paired. Once the earbuds are paired successfully, they will reconnect to the device automatically.
Button Functions
- Turn on:
- Turn off:
- Play/Pause/Answer/end call:
- Previous song:
- Next song:
- Volume up (+):
- Volume down (-):
- Reject incoming call: Recall:
Indicator Light Status
Turn on: Paired mode:
Paired successfully: Earbuds charging: Earbuds fully charged: Charging case
when charging Charging case charged: Charging case fully charged: Long press
2s Long press 3s Click 1 time Click 3 times on left Click 3 times on right
Double clicks on left Double clicks on right Long press 1s Click 4 times on
left Light flashes red/blue Light flashes red/blue on left, Light off on right
Light off Red light Light off earbuds: Green light Red light flashes Red light
is always on
Specifications
- Driver Unit: 13mm Li-ion Battery: 3.7V Battery Capacity: 30mAh Play
- Time: 3 Hours Total Playtime: 10 Hours Charging Time: 1 Hour Wireless
- Range: 30 Feet FCC ID: 2AJUM-AC-STS-L FCC ID: 2AJUM-AC-STS-R
Caution:
a) PCB of battery should not be crushed and twisted.
b) Cell body should not be blended.
c) Do not disassemble and Do not dispose of in fire.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirem
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Operation temperature range: 45°C
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>