PAC LPHGM71 LPH Harness Installation Guide
- June 9, 2024
- PAC
Table of Contents
PAC LPHGM71 LPH Harness Installation Guide
Wiring Connection Chart (All Models)
MODELS
- LPA-E4
- LPA2.4 / LPA2.2
- LPA1.4 / LPA1.2
Important Note: This harness is provided with a inline fuse installed. Please
remove prior to install and reinsert once finished. If your vehicle does not
provide ACC source your harness will not have a “RED” wire to connect. It will
use DC Offset to turn on as well as trigger the “REM OUT” on the LPA. On
LPA-E4 there will be a jumper that you can move based on your application.
This harness is designed to work on OEM NON-AMPLIFIED systems. Connect the RED
BUTT Connector to the aftermarket system turn on for your amplifiers.
Example Installation – 4-Channel Amplifier – (HARNESS CUT REQUIRED)
-
Cut the harness close as possible to the “CUT HERE AND INSULATE” label. You must insulate wires to prevent damage to OEM radio.
-
The cut speaker wires will need to be connected to your aftermarket amplifier. (REFER TO LABEL ON HARNESS)
-
Please refer to the chart on the first page for wiring your loose wires to your LPA.
-
This harness is designed to work on OEM NON-AMPLIFIED systems
-
If using a 2-Channel input LPA use the front speaker wires and insulate the remaining rear speaker wires.
-
DO NOT CUT the speaker wires inbetween the “CUT HERE” Lables in order to keep the factory speakers functional.
-
This harness is designed to work on OEM NON-AMPLIFIED systems.
-
Amp is larger/Black
-
ANC is small/Silver
-
Amp has 3 plugs Actually black in the vehicle
-
ANC has 2 plug
ANC vs Amplifier
ANC / Amp Location 2019+ RAM 1500
ANC / Amp Location 2019+ RAM 2500/3500
ANC / Amp Location Jeep Cherokee
**ANC / Amp Location Chrysler Pacifica
**
ANC Location 2015-2016 Grand Cherokee
Documents / Resources
| PAC
LPHGM71 LPH
Harness
[pdf] Installation Guide
LPHGM71, LPH Harness, LPHGM71 LPH Harness
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>