Loctek ERGONOMIC QI02S Wireless Charger User Manual

June 9, 2024
Loctek ERGONOMIC

Loctek ERGONOMIC logo Item No.: QI02S
Wireless Charger
User Manual

Specification

Input Voltage 20-36V 1A Max
Output Power 5W/7.5W/10W Max
Product Size Converter50×30×17.7 ,ChargerΦ59.5×16.5
Effective Transmission Distance 0-8mm ( Between wireless charger TX coil and

RX coil)
Power Supply Mode| Control box output 33V to power
TX/RX Frequency Rang| 115KHz – 178KHz
Radiate H-Field| 27.54dBuA/m@3m

Installation

Loctek ERGONOMIC QI02S Wireless Charger - Figure 1Connect wireless charger with DC port of control box, control box connects power for using.
Operation Instruction
Place the wireless device on the wireless charging area while the power is connected. A buzzer sounding “DI”, indicating that the phone is charging.
Attention: Do not place any other object between the smart phone and the Wireless Charging Module. The smart phone may not charge properly

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Declaration of Conformity
Hereby, Loctek Ergonomic Technology Corp. declares that the product type QIO2S is in compliance with Directives 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.loctekmotion.com
WARNING: Read all safety information below and operating instructions before using this wireless charger to avoid injury and damage to your device.
Failure to follow these Safety instructions could result in fire, electric shock, or other injury or damage.

  1. Do not use or place the product in or near fire, stoves, or other high temperature location, which may cause the product to overheat or fail and result in a risk of fire or explosion.
  2. Do not expose the product to water or rain, don’t allow any liquid to get inside the product- Electric shock may result.
  3. Keep the unit away from heat source and direct sunlight. Use the product in a location with the temperature of 32℉ (0℃) – 95℉ (35℃).
  4. Do not place metal part, magnetic cards or similar items near the product.
  5. Never atiempt to repair or disassemble the product for any reason, incorrect disassembling or repairing may cause the risk of electronic shock or fire.
  6. Keep the unit out of reach of children.

Loctek Ergonomic Technology Corp.
588 Qihang South Road
Binhai Industrial Zone
Yinzhou District
Ningbo
315145 Zhejiang
P.R. China

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals