Loctek Ergonomic Technology MS104WXCD Wireless Charger User Guide
- June 6, 2024
- Loctek Ergonomic Technology
Table of Contents
Loctek Ergonomic Technology MS104WXCD Wireless Charger
Thank you for purchasing and using this product!
Please read this Operation Instruction carefully and keep it properly before
using this product.
Product Specification
- Input:DC 12V/DC 1.5A
- Output:5/7.5/10/15W
- Working Distance:3mm
- Charging Efficiency:70%
- Standard: QI
- Quality: Quality and meet CE/FCC/ROHS
- Operation frequency:115.54kHz-175.48kHz .
- H-field:-7.2dBμA/m at 10m
- Hardware:56021-01-RevA
- Software:56021-01-RevA
Application Devices
Compatible with Peregrine
FCC ID:2ARK8-MS104WXCD
Connect the SR-4.2 2PIN terminal at the power cord end to the DC input
interface of the smart desk, then the smart desk supply DC 12V power to the
device, then the device starts to work
Attention
- Please keep the charger away from water or other liquid.
- if you need to clean the charger, please make sure it is not connected power supply.
- Using Environment temperature remains -20-S0’C
This equipment has been tested and found to comply with the limits for a WPC
device, pursuant to Part 15 of the FCC Rules.
These limits were designed to provide reasonable protection against harmful
Interference In a residential Installation.
Caution
Changes or modificatlon1 no expressly approved’ by the pal1y responsible for
compliance could void the user’s authority to operate the product.
Note: This equipment has been tested and found to comply with the limits
for a wireless power charger. pursuant to Part 15 or the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference In a residential Installation. This equipment generates
uses and can radiate radio frequency energy and, If not Installed 11th used in
accordance with the Instructions may cause harmful interference to radio
communications. However, there Is no guarantee that interference will not
occur In a particular Installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user Is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment Into an outlet on a circuit different from that to wh ch the receiver Is connected.
- Consult the dealer or an experienced radio/l”V technician for help
FCC Radiation Exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Manufacturer: Loctek Ergonomic Technology Corp.
Address:588 Qihang South Road Binhai Industrial Zone
Yinzhou District Ningbo, Zhejiang 315145 P.R. China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>