SHANTOU S2 Stunt Spray Car Instruction Manual

June 9, 2024
SHANTOU

SHANTOU S2 Stunt Spray Car Instruction Manual
SHANTOU S2 Stunt Spray Car

Remote Control Instructions

Remote Control

Batteries and Charging

Battery installation for remote control
Battery safety information

  1. Battery requirement Vehicle use 3.7V battery; remote control requires 2 x 1.5V “AA” non-rechargeable batteries.

  2. Install and remove battery properly.

  3. Do not recharge non-rechargeable batteries.

  4. Do not mix old and new batteries or different types of batteries

  5. Use only batteries of the same or equivalent type as recommended

  6. Insert batteries with correct polarity.

  7. Ways remove exhausted batteries from the toy

  8. Rechargeable batteries are only to be charged under adult supervision.

  9. Remove rechargeable batteries from the toy before charging

  10. Do not short-circuit the supply terminals.

  11. Loosen the screw in the battery compartment door with a Phillips screwdriver.

  12. Install 2 x 1.5V -AK batteries with correct polarity (+1-) as shown inside.

  13. Replace the battery door and tighten the screw.

Charging diagram of vehicle

  1. Loosen the screw and remove the battery door.
    Remove the exhausted battery pack and install a fully charged one, making sure the battery connected with correct polarity (+/-).
    Replace the battery door and tighten the screw.

  2. Connect one end of the USB charger cable to batten/other end of the USB charger cable can charge the battery by connecting a power supply medium with a USB socket
    (For example, notebook computer, power adapter).
    The charging time is 65 minutes.
    NOTE: Only use chargers specifically designed to charge the included vehicle.

Fill With Water for the Vehicle

Fill the water-tube first, then remove the plug from the vehicle (Fig. 1) and insert the water tube into the small hole of the vehicle, gently squeeze the water-tube to fill the vehicle **(Fig. 2).


NOTE:** Do not overfill the vehicle as this may cause leakage.

Trouble Shooting Guide

Problem Cause Solution

Remote control
does not work| 1. Batteries are installed incorrectly.| 1. Check that the batteries are installed with correct polarity (+/-) as shown inside the battery compartment.
2. The battery is low.| 2.  Replace new batteries.
3.Vehicle is out of range of remote control.| 3. Ensure the distance of remote control within 40 meters. point remote control at the vehicle.
4. Fail to link remote control with vehicle.| 4. Remove and reinstall the batteries to the remote control.
Re-set the vehicle OFF to ON.
Move the sticks on the remote control to re-link remote control and vehicle.
Vehicle does
not work properly| 1. The power switch is in the ‘OFF” position.| 1. Turn the power switch to the “ON’s position.
2. The vehicle is slew to respond.| 2. Charge the vehicle.
3. Vehicle is out of range of remote control.| 3. Remove and reinstall the batteries to the remote control.
Reset the vehicle OFF to ON.
Move the sticks on the remote control to re-link remote control and vehicle.

How To Play

Power ON: Pull the power switch of the remote control car to the “ON” position, then turn on the power switch of the remote control,lf the operation indicator of the remote control is always on.
the linking is successful Remote control distance: about 30-40 meters.
Operating time: When fully charged, it takes about 25 minutes in slow mode and 20 minutes in fast mode.
Note: Always switch vehicle OFF when not in use to avoid reducing the life of the vehicle.

  1. Forward
    Push the left stick up to run forward.
    Push and hold the left stick up will make the vehicle keep driving forward.
    Playing Instruction

  2. Backward
    Push the left stick down to run backward.
    Push and hold the left stick down will make the vehicle keep driving backward.
    Playing Instruction

  3. Turn left
    Push the right lever to the left and the telecar turns left Keep pushing the right lever to the left, and the telecar will keep turning left.
    Make a continuous turn to the left in circle.
    Playing Instruction

  4. Turn left
    Push the right lever to the left and the telecar turns left Keep pushing the right lever to the left, and the telecar will keep turning left.
    Make a continuous turn to the left in circle.
    Playing Instruction

  5. Spray acceleration
    Press the “spray speed” button, the telecar will go into high-speed mode, the movement becomes faster, more flexible control, And the tail fog keep coming out.
    Playing Instruction

  6. Upright driving
    Pull the left lever back and then push it forward quickly to pull up the front of the car to drive
    Playing Instruction

  7. Rotate in place
    Push the remote control stick arbitranlly to the right or left.
    you can rotate to the left or right, continue to push can continue to rotate.
    Playing Instruction

  8. Auto demo
    Press the auto demo button to watch the vehicle perform the built-in demo function.
    Playing Instruction

Warning:
Children should be supervised during play.
Please keep this instruction manual for future reference, as it contains important information.

FCC Statement

FCC ID: 2A7SC-C2 Product Name: C2 stunt remote control vehicle
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SHANTOU User Manuals

Related Manuals