ROBE RW 001 Wireless DMX or RDM Module User Manual
- June 9, 2024
- ROBE
Table of Contents
ROBE RW 001 Wireless DMX or RDM Module
ROBE wireless DMX/RDM module has full support for wireless communication protocols at entertainment market. Modul is based on well known LumenRadio RF technology, with implemented wire interface for connection with Robe products. RF output for MCX interface antenna as standard output.
Supported protocols
- Full RDM support
- CRMX, W-DMX™ G2, G3, G4 and G4S
Block diagram + PCB blocks
Absolute maximum ratings
VDD | Supply voltage | -0,3V to 7V |
---|---|---|
Va, Vb | RS485 signals A, B | -10V to 15V |
– | Other pins | -0,3V to 4V |
Tstorage | Storage temperature | -40 to 125°C |
Operating conditions
Symbol | Parameter | Min. | Typ. | Max. | Unit |
---|---|---|---|---|---|
VDD | Supply voltage (pin 5 to GND) | 4.75 | 5.0 | 5.25 | V |
IDD | Supply current (into pin 5) | 40 | mA | ||
TA | Operating temperature | -20 | 70 | °C | |
VIL | Input voltage logic low (pin 7, 11, 12) | -0.3 | 1,16 | V | |
VIH | Input voltage logic high (pin 7, 11, 12) | 1,54 | 3.6 | V | |
Va, Vb | RS485 signals (pins 8, 9 to GND) | -7 | 12 | V | |
Va-b | RS485 differential (Pin 8 to 9) | 12 | V | ||
frange | Operating frequency range | 2402 | 2480 | MHz | |
RXsens | Receiver sensitivity (0.1% BER) | -93 | dBm | ||
Pout | Output power | 100 | mW |
Connectors
Module communication connector | General purpose 2.54 header |
---|---|
RF connector | MCX – receptacle female socket |
Compliants
- ETSI EN 300 328
- FCC certified
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The [Device] wireless operation is safe and complies to RF Exposure requirements
ROBE lighting s.r.o. Palackeho 416, 75701 Valasske Mezirici, Czech Republic
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>