Varia Hand Grinder Stainless Steel Burr User Manual
- June 9, 2024
- Varia
Table of Contents
INSTRUCTION MANUAL
Thank you very much for your purchase. For directions on how to use the product, pleose be sure to read the instruction manual. After rending the manual, store it in a safe place.
HAND GRINDER
STAINLESS STEEL BURR
Created for coffee enthusiasts and specialty coffee connoisseurs, the Varia
Hand Grinder is a high performance coffee hand grinder with advanced burr
design and a lightweight aluminium body and drive assembly.
Our burr set is constructed using a high nitrogen stainless steel which is the
optimum material for and ultra hard and sharp edge surface with maximum
longevity and
resistance.
Engineered to achieve the highest performace of grind particle distribution
and consistency our burr design utilises advanced geometries and tolerances
providing an extremely consisent grind result with a highly refined particle
distribution from coarse grind sizes for hand brewing to fine grind sizes for
espresso!
Our grinder also features a dual ball bearing drive assembly which ensures an
ultra smooth and stable function. We have also chosen to use an all aluminium
body contruction hat has the drive assembly supports cast in one part for the
most strength and ridgidity through the torque crank.
GRIND ADJUSTMENT
VARIA BURR ASSEMBLY
- Assemble the body by sliding the driveshaft with the upper bearing & washer into the central hole of the grinder body. The upper washer (flat side facing up) should be flush with the tri-frame.
- Place the handle onto the grinder and invert the grinder vertically. Rotate the handle so that the driveshaft has the two flat sides facing up/down and the Varia logo is at the top.
- Place the lower bearing & washer (flat side facing up) + spring + lower burr onto the driveshaft (in this order).
- Rotate the burr so that the alignment hole is at the top and in-line with the Varia logo.
- Place the fixing plate onto the burr (number side facing up) ensuring the alignment pin connects with the hole in the burr.
- Lastly, place the adjustment cap onto the top of the fixing plate with the dot in-line with (#24). Once aligned, push down and slowly turn and thread the adjustment cap onto the driveshaft and tighten to the finest point called “Start-Point Also ensure the cap does not cross-thread, if adjustment cap does not thread smoothly and level, turn back and restart the thread.
- From “Start to Finish’ of tightening the adjustment cap, 4.75 x complete rotations are required to reach the finest setting.
SAFETY AND CAUTION
Please don’t let children play with this coffee grinder. It is heavy, it has
very sharp blades. Please be careful with your fingers when you operate close
to the burr edges or assemble/ disassemble the burr assembly. The edges of
Burt are extremely sharp. You can easily cut and harm yourself if you are not
careful.
Also be careful when gripping the body of the grinder while wearing jewelery
as they may cause scratches to the surface.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>