LIVEX 47166, 47168 6 Light 25 Inch Chandelier Instruction Manual
- June 9, 2024
- LIVEX
Table of Contents
LIVEX 47166, 47168 6 Light 25 Inch Chandelier
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR
ASSEMBLING THE FIXTURE (Fig.1)
-
Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
-
While holding the end coupling sleeve of pipes(J) onto the screwed connection of big ring(K), the other end pipe thread insert to the bottom hole of ball, lock it securely with the cone nut(I), use the same method install other pipes. Slide the pipe thread(H) insert to the hex coupling in the ball and lock it with the end hex nut. Slide the cover(G) onto the ball and lock it with the column nut(F).
-
Slide the electrical wires through the tubes(E)/(D)/(C) and canopy (A).
-
Raise the tube (E) to top pipe screw of lamp body, raise the tube (C)/(D) and canopy (A) to the pipe screw in order, then by turning it clockwise until tight.
-
Install the light bulbs (Not included) in accordance with the fixture specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
-
Thread the two mounting screws into the pre-drilled holes in the Mounting plate spaced the same distance apart as the holes in the canopy. Attach the Mounting plate to the Junction Box with the two Junction Box screws as shown. The side of the Mounting plate marked “GND” must face to out. The junction box is not included.
-
While holding the assembly lamp towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture’s ground wire directly to the Mounting plate with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box.
-
Raise the canopy (A) on to the Junction box, aligning screws on mounting plate with mounting holes in canopy and lock it securely with the ball nuts (B).
Your installation is now complete. Return power to the junction box and test the fixture.
CUSTOMER SUPPORT
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at:
800-761-8056
Or visit us online at:
WWW.LIVEXLIGHTING.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>