Strand RDM-6WALL Signal Splitter User Guide
- June 9, 2024
- Strand
Table of Contents
Strand RDM-6WALL Signal Splitter
OVERVIEW
This is a wall mounted 6 way RDM splitter, featuring one RDM IN / THRU and 6 RDM OUTPUTS. This unit takes the incoming RDM/DMX signal and splits the signal into six separate OUTPUT channels. Each OUTPUT and the IN / THRU are completely electronically isolated from each other, all six OUTPUT ports have independent output driver to boost the RDM / DMX signal.
INSTALLATION AND SET UP
MOUNTING
To mount RDM-6WALL Signal Splitter:
Step 1. Drive 4 screws into the wall according to the position of the
housing.
Step 2. Aim the 4 mounting hole to the 4 screws driven into the wall.
Step 3. Move the unit downwards, the whole unit is settled.
NOTE: The socket-outlet shall be installed near the equipment and shall
be easily accessible.
DATA CABLE (DMX CABLE) REQUIREMENTS
The RDM-6wall is controlled via DMX-512 protocol and your DMX controller
requires a standard 3-pin terminal connector for data input and data output.
Connect the RDM-6wall and your fixtures together using standard 3 pin DMX
cables. The RDM-6wall uses DMX-512 protocol to operate your fixtures.
Terminate the DMX/RDM THRU port on the last unit in the data run by attaching
a 120ohm, 0.5W resistor between Data + and Data – wires.
WARNINGS AND NOTICES
When using electrical equipment, basic safety precautions should always be
followed including the following:
- For indoor, dry locations use only. Do not use outdoors.
- Do not mount near gas or electric heaters.
- Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
- The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition and void warranty.
- Not for residential use. Do not use this equipment for other than intended use.
©2021 Signify Holding. All rights reserved.
All trademarks are owned by Signify Holding or their respective owners. The
information provided herein is subject to change, without notice. Signify does
not give any representation or warranty as to the accuracy or completeness of
the information included herein and shall not be liable for any action in
reliance thereon. The information presented in this document is not intended
as any commercial off er and does not form part of any quotation or contract,
unless
CUSTOMER SERVICE
If you have any questions regarding this product,please contact Customer
Service by phone at +1 214-647-7880 or
by email at entertainment.
service@signify.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>