NEXA LEST-701 Range Extender Instruction Manual

: June 9, 2024
: NEXA

Table of Contents

NEXA LEST-701 Range Extender
TECHNICAL DATA
PAIRING WITH TRANSMITTERS
DELETE PAIRED TRANSMITTERS FROM MEMORY
DELETE ALL PAIRED TRANSMITTERS FROM MEMORY
INSTALLATION
LOW BATTERY
OTHER INFORMATION
INSTRUCTION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

NEXA LEST-701 Range Extender

TECHNICAL DATA

Battery 2 X AA (not included)
Frequency System Nexa (433,92 MH2) up to 30 m
Range Operating temperature
IP rating -20 to +40 °C
IP56 (waterprotected)
Dimensions, W x Hx D 60 x 80 x 20 mm

Battery-powered range extender that repeats incoming signals from transmitters to increase the range between transmitter and receiver.
LEST-701 can repeat signal for a maximum of 6 pcs. channels, a channel corresponds to an ON /OFF button on a remote control or other System Nexa transmitter.
Place LEST-701 between the transmitter and receiver for optimal range. Can be placed on a table surface or mounted on a wall.

PAIRING WITH TRANSMITTERS

Briefly press the learn button, LED indication flashes slowly.
Depending on the transmitter type
- Remote control; Press “ON” for the selected channel to be paired
- Motionsensor: Move the LEARN” Switch from “DEL” to “SET”
- Door/window sensor: See respective product manual, section “Pairing”
The LED indication flashes twice to confirm pairing.

DELETE PAIRED TRANSMITTERS FROM MEMORY

Briefly press the learn button, LED indication flashes slowly.
Depending on the transmitter type
- Remote control;
  Press “OFF for the selected channel to be deleted
- Motionsensor:
  Move the “LEARN” Switch from “SET to “DEL”
- Door/window sensor
  See respective product manual, section “Delete”
The LED indication flashes twice to confirm deletion.

DELETE ALL PAIRED TRANSMITTERS FROM MEMORY

Press the learn button for 6 seconds, LED indication flashes rapidly.
Release the learn button, then press it briefly again.
LED indication flashes twice to confirm deletion.

INSTALLATION

Remove the stand / bracket and unscrew the battery cover
Insert two AA batteries
Pair with transmitters
Fit the battery cover.
Mount the bracket on LEST-701and place it on a table or on the wall.

LOW BATTERY

The LED indicator flashes continuously every three seconds at low battery voltage

OTHER INFORMATION

Range indoors: up to 30 m (optimal conditions). The range is very dependent on local conditions, if there is metal in the vicinity for example. The thin metal coating in low emissivity energy glass has a negative effect on the range of radio signals for example. There may be restrictions on the use of the unit outside the EU. If appropriate, you should check that the unit complies with local regulations.

Max. load: Never connect bulbs or equipment that exceed the maximum load of the receiver. This could lead to faults, short- circuiting or fire. Life- support equipment: Never use Nexa’s products for life- support equipment or other devices where faults or interference could have life-threatening consequences.

Interference: All wireless units can suffer from interference that can affect performance and range. Because of this, the minimum distance between two receivers should be at least 50 cm

Repair: Do not attempt to repair the product. It does not contain any repairable parts.

Watertightness: The product is not waterproof. Make sure it remains dry at all times. Damp will cause the internal electronics to corrode and this could lead to short-circuiting, faults and a risk of electric shock.

Cleaning: Clean the product using a dry cloth. Do not use chemicals, solvents or strong cleaning agents.

Environment: Do not expose the product to intense heat or cold as this could damage or shorten the service life of the electric circuits.