Knightsbridge ORA1TRB Tilt Square Downlight Instruction Manual
- June 9, 2024
- Knightsbridge
Table of Contents
Knightsbridge ORA1TRB Tilt Square Downlight
GENERAL INSTRUCTIONS
- These instructions should be read carefully and retained after installation by the end user for future reference and maintenance.
- These instructions should be used to aid installation of the following products: ORA1TRB / ORA1TRW / ORA1TSB / ORA1TSW
SAFETY
- This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
- Please isolate mains prior to installation or maintenance
- Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
- This product is for indoor use only
- This product is Class II double insulated
- This product is IP20 rated
INSTALLATION
- Provide power to the required point of installation
- Unscrew the baseplate from the downlight
- Using the baseplate as a template, mark the location for, and drill the fixing holes ensuring not to infringe with any gas/water pipes or electrical cables (see Fig. 1)
- Feed the mains cable through baseplate hole and secure it to the surface using the screws and wall plugs provided
- Connect the lamp holder to the mains supply ensuring the correct polarity is observed: L – Live (brown) and N – Neutral (blue)
- Remove the inner bezel by pulling it down and insert a suitable LED GU10 lamp ( see Fig. 1)
- Reattach the inner bezel and the body of the downlight to the baseplate
- Switch on and check for correct operation
GENERAL
- Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage the product.
- This product is dimmable dependent on lamp type.
- This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where facilities exist.
WARRANTY
This product has a warranty of 5 years from date of purchase. Failure to
install this product in accordance with the current edition of the IEE Wiring
Regulations (BS7671), improper use, or removal of the batch code will
invalidate the warranty. If this product should fail within its warranty
period, it should be returned to the place of purchase for a free of charge
replacement. ML Accessories does not accept responsibility for any
installation costs associated with the replacement product. Your statutory
rights are not affected. ML Accessories reserve the right to alter product
specification without prior notice.
- ML Accessories Limited LU5 4LT
- www.mlaccessories.co.uk
Documents / Resources
|
Knightsbridge ORA1TRB Tilt Square
Downlight
[pdf] Instruction Manual
ORA1TRB, ORA1TRW, ORA1TSB, ORA1TSW, ORA1TRB Tilt Square Downlight, ORA1TRB,
Tilt Square Downlight, Square Downlight, Downlight
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>