aidapt VM936R Easy Lift Assist Cushion Instructions
- June 9, 2024
- Aidapt
Table of Contents
VM936R Aidapt Lift Assist Cushion
VM936R Usage and Maintenance Instructions
INTRODUCTION
Thank you for deciding to purchase the Lift Assist Cushion from Aidapt.
NB. A RISK ASSESSMENT SHOULD BE UNDERTAKEN AS TO THE SUITABILITY OF THE
PRODUCT FOR THE PARTICULAR USAGE.
NB. THIS EQUIPMENT MUST BE INSTALLED BY A COMPETENT PERSON
Maximum User Weight Limit 127kg (20 Stone)
Do not exceed the stated weight limit – doing so could put the user at risk.
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp
instruments as this may damage the surface of the product.
Check the product for any visible damage if you see any damage or suspect a
fault, do not use your product, but contact your supplier for support.
INTENDED USE
This Lift Assist Cushion from Aidapt is designed to be used to help gently
raise the user in and
out a chair or sofa.
ADJUSTING THE GAS LIFTING MECHANISM
Turn the cushion on its side and reach underneath the rear of the cushion. You will see a bar that runs three quarters of the length of the base. Pull back on the widest part of the bar connected to the lifting mechanism so that it releases from the resistance grooves. (See Fig 1).
Move the connector to the appropriate slot and push until the connector is
properly in place. See Fig. 2 and 3. The lift assist cushion is now ready to
use.
INSTRUCTIONS FOR USE
Position the Lift Assist Cushion onto your chair ensuring the surface area is
level and free from any obstructions that may compromise the stability of the
product. The lift assist cushion should be used on a chair with arms. The
cushioned area should ideally overhang the front of the chair. When ready to
sit down ensure your weight is distributed evenly on the flat part of the top
of the cushion. The lift assist cushion will gently ease you down slowly into
your chair. If the cushion does not go down when you sit in it then you will
need to adjust the gas lift setting underneath the cushion area.
When using the lift assist cushion to sit up and down the user should have
both hands on the arms of the chair and their feet flat on the floor at
shoulder width apart. When rising out of a chair the user should lean slightly
forward and push off with the arms and legs. The lift assist cushion will
gently lift the user out of the chair (See Fig. 4).
NB. The Lift Assist Cushion is not recommended for use in wheelchairs, automobiles, reclining chairs or chairs with non-lockable wheels.
WARNING – ENTRAPMENT
- THIS PRODUCT IS NOT TO BE USED BY CHILDREN.
- When sitting and raising from the seated position please ensure your hands/arms are clear and do not get trapped in the mechanism. (See Fig. 5).
- Please ensure any objects, pets and children are clear of the mechanism when sitting.
CLEANING
The cover of the Lift Assist Cushion is removable and can be hand washed at low temperature using a mild detergent. Abrasive cleaners e.g. AJAX and/ or abrasive cleaning pads may damage the product beyond repair and should not be used. The cover should be dried flat away from a heat source.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all components for their safety. If in any doubt, please do not issue or use, but immediately contact your supplier for service support.
CARE & MAINTENANCE
Please make a safety check of the product at regular intervals or if you have
any concerns.
IMPORTANT INFORMATION
The information given in this instruction booklet must not be taken as forming
part of or establishing any contractual or other commitment by Aidapt
Bathrooms Limited, Aidapt (Wales) Ltd or its agents or its subsidiaries and no
warranty or representation concerning the information is given. Please
exercise common sense and do not take any unnecessary risks when using this
product; as the user you must accept liability for safety when using the
product. Please do not hesitate to contact the person who issued this product
to you or the manufacturer (detailed below) if you have any queries concerning
the assembly/use of your product.
Aidapt Bathrooms Ltd, Lancots Lane,
Sutton Oak, St Helens, WA9 3EX
Telephone: +44 (0) 1744 745 020
Fax: +44 (0) 1744 745 001
Web:www.aidapt.com
Email:sales@aidapt.co.uk
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>