ergotron 102236 Pullplate Trim User Guide
- June 4, 2024
- ERGOTRON
Table of Contents
ergotron 102236 Pullplate Trim User Guide
Learn Fit™
Components
|
|
---|---|---
**Tools Needed
**
Assembly instruction
-
Remove base orientation indicator from base.
-
Partially insert riser into base.
-
Remove cap.
-
Attach work surface and press down.
-
Lift up on the work surface to make sure it is securely attached to the base.
-
- Lift brake release lever to raise and lower riser.
- Lift brake release lever to raise and lower riser.
-
Loosen, but do not remove 2 screws to lift and lower hook to desired height.
How to Disassemble
To remove work surface, push tab with a tool while removing.
(Hex wrench suggested, max diameter 4 mm)
NOTE: Requires two people.
Set Your Workstation to Work For YOU!
Learn more about ergonomic computer use at:
www.computingcomfort.org
Height Position top of screen slightly below eye level.
Position keyboard at about elbow height with wrists flat.
Distance Position screen an arm’s length from face—at least 20” (508mm).
Position keyboard close enough to create a 90˚ angle in elbow.
Angle Tilt screen to eliminate glare.
Tilt the keyboard back 10° so that your wrists remain flat.
To Reduce Fatigue
Breathe – Breathe deeply through your nose.
Blink – Blink often to avoid dry eyes.
Break • 2 to 3 minutes every 20 minutes
• 15 to 20 minutes every 2 hours.
For Warranty visit: www.ergotron.com/warranty
For Service visit:
www.ergotron.com
For local customer care phone numbers visit:
http://contact.ergotron.com
NOTE: When contacting customer service, reference the serial number.
Support
www.ergotron.com |
USA: 1-800-888-8458 |
Europe: +31 (0)33-45 45 600 |
China: 400-120-3051 |
Japan: japansupport@ergotron.com
© 2016 Ergotron, Inc. All rights reserved. LearnFit™ is a registered trademarks of Ergotron, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>