ergotron 45-460-026 Lockable Tablet Mount User Guide
- June 3, 2024
- ERGOTRON
Table of Contents
ergotron 45-460-026 Lockable Tablet Mount
Instruction
Safety
-
CAUTION! DO NOT mount tablet with arms on the sides or ends of the tablet. ONLY ATTACH ARMS TO THE CORNERS OF THE TABLET. Failure to follow these instructions will create an unsecured installation and may cause tablet to fall out of holder resulting in possible equipment damage.
-
CAUTION! Support tablet when removing from holder. Pulling holder arm out without supporting tablet will cause the tablet to fall out resulting in possible equipment damage.
-
Important! Always have the lock on the top.
Without lock on top, tablet may come off holder if bumped and result in possible equipment damage. -
Important! Hold handles when moving mounted tablet around.
Not holding handles may cause tablet to come off holder and dropped resulting in possible equipment damage.
Installation
Components
-
Remove Portrait/Landscape rotation lock screw from the mount if its installed.
-
Attach Tablet Mount to 75x75mm or 100x100mm VESA plate.
NOTE: Make sure the lock is facing upward.
Adjustment Step
Adjust your mounting solution to handle the change in mounted weight.
Adjustments should move smoothly and easily through the full range of motion
and stay where you set it. If adjustments are diffi cult and do not stay in the
desired position, follow the instructions to loosen or tighten the tension to
create a smooth, easy adjustment
motion. Depending on your product and the adjustment, it may take several
turns to notice a diff erence.
Features & Specifications
Set the racheting arm to fi t your size tablet and allowing for centered mounting.
There are two options for the racheting arm:
OPTION 1. As shipped, arm can be adjusted.
OPTION 2. Lock arm in place. Install the long pin into the left slot.
Set Your Workstation to Work For YOU!
Height Position top of screen slightly below eye level.
Position keyboard at about elbow height with wrists fl at.
Distance Position screen an arm’s length from face—at least 20” (508mm).
Position keyboard close enough to create a 90˚ angle in elbow. Angle Tilt
screen to eliminate glare.
Tilt the keyboard back 10° so that your wrists remain fl at.
For Warranty visit:
www.ergotron.com/warranty
For Service visit: www.ergotron.com
For local customer care phone numbers visit: http://contact.ergotron.com
NOTE: When contacting customer service, reference the serial number.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>