SCOTT V01 360 Wh HPR Battery User Manual
- June 9, 2024
- SCOTT
Table of Contents
BATTERY MANUAL
HPR Battery V01 360 Wh
User Manual
Safety
These instruction contains information that you must observe for your personal
safety and to prevent personal injury and damage to property. They are
highlighted by warning triangles and shown below according to the degree of
danger.
► Read the instructions completely before start-up and use. This will help you
to avoid hazards and errors.
► Keep the manual for future reference. This user manual is an integral part
of the product and must be handed over to third parties in case of resale.
NOTE
Also observe the additional documentation for the other components of the
HPR50 drive system as well as the documentation enclosed with the e-bike.
1.1 Hazard classification
HAZARD
The signal word indicates a hazard with a high degree of risk which will
result in death or serious injury if not avoided.
WARNING
The signal word indicates a hazard with a medium level of risk which will
result in death or serious injury if not avoided.
CAUTION
The signal word indicates a hazard with a low level of risk which could result
in a minor or moderate injury if not avoided.
NOTE
A note in the sense of this instruction is important information about the
product or the respective part of the instruction to which special attention
is to be drawn.
1.2 Intended Use
The HPR Battery is intended exclusively for supplying power to the HPR50 drive
system and must not be used for any other purposes. Any other use or use that
goes beyond this is considered improper and will result in the loss of the
warranty. In case of non-intended use, TQ-Systems GmbH assumes no liability
for any damage that may occur and no warranty for proper and functional
operation of the product. Intended use also includes observing these
instructions and all information contained therein as well as the information
on intended use in the supplementary documents enclosed with the e-bike.
Faultless and safe operation of the product requires proper transport,
storage, installation and operation.
1.3 Safety instructions for the HPR Battery
— Risk of explosion and fire if Battery housing is damaged.
-
If the housing is damaged, be sure to have the Battery replaced by a bicycle dealer authorized by TQ even if the Battery is still functional.
-
Do not make any repair attempts under any circumstances.
— Explosion and fire hazard when short-circuiting the Battery terminals. -
Keep the Battery away from metallic objects as there is a risk of short-circuit. Do not allow nails, screws or other small, sharp and/ or metallic objects to come into contact with the Battery (charging/ discharging socket).
— Risk of explosion and fire in case of high heat, fire or contact with water.
Protect the Battery from fire, high heat and also from extended direct exposure to sunlight. -
Never immerse the Battery in water.
— Danger of poisoning from gases of a smoking or burning Battery in case of damaged Battery or improper use. -
Be careful not to breathe in the highly toxic gases from a smoking or burning Battery.
-
Ensure good ventilation and consult a doctor if you notice any undesirable effects on the respiratory organs. The vapors may irritate the respiratory organs.
— Liquid may leak from the Battery if used improperly. Avoid any contact with this liquid. Wash it off with water if you do come into contact with the liquid. Also seek medical attention if the liquid has come into contact with your eyes. Liquid leaking from the Battery can cause irritation or burns.
— Never subject the Battery to mechanical shocks to prevent damage to the Battery.
— Only adults are allowed to handle the Battery. Keep the Battery away from children.
Never open the Battery case or attempt to disassemble the Battery.
— Never break or puncture the Battery.
— Only charge the Battery in well-ventilated rooms.
— Only use the intended TQ charger to charge the Battery.
— Use only original HPR batteries to supply power to the drive system.
Technical data
| Nominal voltage | 50,4 V |
|---|---|
| Nominal capacity | 6,8 Ah |
| Nominal energy | 360 Wh |
| Dimensions | 48 mm x 63,5 mm x 370 mm / |
1,89” x 2,5” x 14,57”
Protection class| IP67
Charging temperature
Operating temperature
Storage temperature| 0 °C to 40 °C / 32 °F to 104 °F
-5 °C to 40 °C / 23 °F to 104 °F
10 °C to 20 °C / 50 °F to 68 °F
Weight| approx. 1.835 g / 4,04 lbs
Tab. 1: Technical data – HPR Battery
Operation
3.1 Battery charging
WARNING
Fire or electric shock hazard due to damage to Battery, Range Extender,
charger, cable and plug
► Never charge the Battery if you notice any damage to the Battery, Range
Extender, charger, cables or connectors.
► Only perform the charging process in a place where there are no flammable
materials in surrounding.
► Never leave the charging process unattended.
NOTE
You can charge the Battery either directly with the charger or via the
optional Range Extender. For more information, refer to the corresponding user
manuals for the charger and the Range Extender.
► Connect the charger to the power supply.
► Unfold the cover (pos. 1 in fig. 1) on the charging port (pos. 2 in fig. 1)
in the bike frame.
► Check that the contacts in the charging port are free of dirt and clean them
if necessary.
► Align the charging plug (pos. 3 in Fig. 1) of the charger or Range Extender
so that the plug codes of the charging plug and charging port match (see Fig.
1).
► Insert the charging plug (pos. 3 in Fig. 1) of the charger or Range Extender
into the charging port.
► Pull the charging plug out of the charging port when charging is complete.
► Close the cover on the charging port when charging is complete and
disconnect the charger from the power supply.
3.2 Note on Charging
NOTE
The temperature of the Battery must be within the permissible charging
temperature range (0 °C to 40 °C / 32 °F to 104 °F). Otherwise the charging
process will not be started.
— The drive system is deactivated during the charging process.
— The state of charge of the Battery can be read on the Display. (It is also
possible to check the state of charge directly on the Battery on the 5 LEDs.
Cover the light sensor next to the LEDs with a finger briefly to activate this
indication).
— The state of charge of the Range Extender can be read on the Display and on
the 5 LEDs on the side of the Range Extender.
— New batteries have a charge level of 20% to 30% due to transportation
regulations and must be recharged within less than 6 months of manufacture.
— The Battery should be recharged immediately after complete discharge (state
of charge <5 %).
— 1 charge cycle can consist of a full charge of the Battery capacity (0% to
100%) or several partial charges that add up to 100% of the charge capacity.
— The Battery capacity should be at least 60% after 500 charging cycles.
— Derating: In case the Battery capacity gets almost empty (approx. <10%)
during riding the sytems switches automatically to mode I.
Transport
— The transport of lithium batteries is subject to country-specific laws and
regulations. Inform yourself about the respective regional regulations and
observe them during transport.
— For transport observe the special requirements for packaging and labeling
that apply in your country.
— Contact a TQ authorized bicycle dealer for information on transporting the
Battery and suitable transport packaging. For transport outside the bicycle
frame, we recommend a certified transport box.
Storage
— Store the Battery at room temperature (approx. 10 °C to 20 °C / 50 °F to 68
°F ) and do not expose it to direct sunlight.
— Do not store the Battery near heat sources or other easily flammable
materials.
— Store the Battery in dry rooms (humidity below 70%) and protect it from rain
and moisture.
— Store the Battery only in rooms equipped with smoke detectors.
— Charge the Battery to approx. 30 % to 60 % before storage.
— Check the Battery every 6 months and recharge it to approximately 30% to
60%.
— Fully charge the Battery before use.
— Do not store the Battery with the charger plugged in.
Cleaning
— Never immerse the Battery in water to clean it.
— Never clean the Battery with a water jet.
— Only clean the Battery with a soft, damp cloth.
— Please contact a TQ authorized bicycle dealer if the Battery is no longer
functional.
Maintenance and Service
All service, repair or maintenance work performed by a TQ authorized bicycle dealer. Your bicycle dealer can also help you with questions about bicycle use, service, repair or maintenance.
Environmentally friendly disposal
**** The components of the drive system and the batteries must not be
disposed of in the residual waste garbage can.
— Dispose of metal and plastic components in accordance with country-specific
regulations.
— Dispose of electrical components in accordance with country-specific
regulations. In EU countries, for example, observe the national
implementations of the
Waste Electrical and Electronic EquipmentDirective 2012/19/EU (WEEE).
— Dispose of batteries and rechargeable batteries in accordance with the
country-specific regulations. In EU countries, for example, observe the
national implementations of the Waste Battery Directive 2006/66/EC in
conjunction with Directives 2008/68/EC and (EU) 2020/1833.
— Observe addtitonally the regulations and laws of your country for disposal.
In addition you can return components of the drive system that are no longer
required to a bicycle dealer authorized by TQ.
NOTE
For more information and TQ product manuals in various language, please visit
www.tq-group.com/ebike/downloads or
scan this QR-Code.
We have checked the contents of this publication for conformity with the
product described. However, deviations cannot be ruled out so that we cannot
accept any liability for complete conformity and correctness.
The information in this publication is reviewed regularly and any necessary
corrections are included in subsequent editions.
All trademarks mentioned in this manual are the property of their respective
owners. Copyright © TQ-Systems GmbH
TQ-Systems GmbH | TQ-E-Mobility
Gut Delling l Mühlstraße 2 l 82229 Seefeld l Germany
Tel.: +49 8153 9308-0
info@tq-e-mobility.com l
www.tq-e-mobility.com
Art.-No.: HPR50-BAT01-UM
Rev0200 2021/11
© SCOTT Sports SA 2022. All rights reserved.
The information contained in this manual is in various languages but only the
English
version will be relevant in case of conflict.
P.E.D Zone C1, Rue Du Kiell 60 | 6790 Aubange | BelgiumDistribution: SSG
(Europe) Distribution Center SA SCOTT Sports SA | 11 Route
du Crochet | 1762 Givisiez | 2022 SCOTT Sports SA www.scott-
sports.com Email: webmaster.marketing@scott-
sports.com
References
- art.no
- sports.com
- scott-sports.com
- Innovative E-Bike Antriebssysteme | TQ
- TQ | Elektronikprodukte und Elektronikdienstleistungen
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>