BRAYER BR4209 Cordless Vacuum Cleaner Instruction Manual

: June 9, 2024
: BRAYER

Table of Contents

BRAYER BR4209 Cordless Vacuum Cleaner
DESCRIPTION
USING THE VACUUM CLEANER
CLEANING AND MAINTENANCE
STORAGE
SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BRAYER BR4209 Cordless Vacuum Cleaner

DESCRIPTION

Floor/carpet brush
«Floor/carpet» switch
Telescopic pipe lock
Telescopic extension pipe
Flexible hose handle
Manual suction power control
Flexible hose
Flexible hose ending
Ending locks
Air inlet
Dust bin
Carrying handle
Dust bin lock button
Power cord winding button
Brush storage
Vacuum cleaner on/off button
Outlet filter
Outlet filter grid
HEPA filter
Separator
Dust bin upper lid lock
Dust bin upper lid
Dust bin flask
Dust bin lower lid lock
. Dust bin lower lid
Universal crevice nozzle
Furniture/furniture upholstery brush

SAFETY MEASURES AND OPERATION RECOMMENDATIONS

Use the unit for its intended purpose only, as it is stated in this manual.
Mishandling the unit can lead to its breakage and cause harm to the user or damage to the user’s property, which is not covered by warranty.
Make sure that the operating voltage of the unit indicated on the label corresponds to your home mains voltage.
To avoid fire, do not use plug adapters for connectingthe vacuum cleaner to the mains.
Do not touch the vacuum cleaner body, the power cord and the power plug with wet hands.
Do not use the vacuum cleaner if the dust bin is not installed or installed improperly, or if the inlet and outlet filters are not installed.
Use only the parts and attachments supplied with the unit.
Never leave the unit connected to the mains unattended.
Do not use the vacuum cleaner outdoors.
It is not recommended to use the unit during lightning storms.
Protect the unit from impacts, falling, vibrations andother mechanical stress.
Do not use the unit near heating appliances, heat sources or open flame.
Do not use the vacuum cleaner in places where aerosols are used or sprayed, and in proximity to highly inflammable liquids; do not use the vacuum cleaner in the places where such liquids are stored.
The vacuum cleaner is not intended for collecting water or other liquids.
Do not use the vacuum cleaner for collecting burning or smoking cigarettes or cinders.
Do not use the vacuum cleaner for collecting dust of plaster, concrete, flour or ashes.
Do not use the vacuum cleaner to clean your pets’ fur.
Keep free hanging clothes, hair and other parts of your body away from the air inlets of the brush or the attachments while room cleaning.
Do not cover the inlets and outlets of the vacuum cleaner with any foreign objects. Do not switch the vacuum cleaner on if any of its openings is blocked.
Do not run over the power cord with the vacuum cleaner while room cleaning to avoid damaging it.
Do not use the power cord as a handle for carrying the vacuum cleaner; carry it by the handle.
Regularly clean the dust bin and the filters of the vacuum cleaner.
After you finish using the vacuum cleaner or before cleaning it, switch the unit off with the on/off button and unplug it

BEFORE THE FIRST USE

Unpack the unit and remove all the packaging materials.
Keep the original package.
Read the safety measures and operating recommendations.
Check the delivery set.
Examine the unit for damages, in case of damage do not plug it into the mains.
Make sure that the given specifications of supply voltage of the unit correspond to the specifications of your mains. When the unit is used with the mains with 60 Hz frequency, no additional action is necessary

USING THE ATTACHMENTS

Floor/carpet brush (1)
When using the brush (1) set the switch (2) to the necessary «FLOOR/CARPET» position Combined crevice nozzle (26)
The combined crevice nozzle (26) can be used for cleaning radiators, crevices or spaces between cushions, as well as for collecting dust from furniture surface.
The pile on the brush prevents damage of polished furniture surfaces. While cleaning, set the brush to the required position.
Furniture/furniture upholstery brush (27)
Use the attachment (27) to clean the furniture upholstery.

ASSEMBLING THE VACUUM CLEANER

Attaching and removing the flexible hose (7)
Insert the flexible hose (7) ending (8) into the air inlet (10) until the locks (9) catch.
To remove the flexible hose (7), press the locks (9) and detach the ending (8) from the air inlet (10).
Attaching the telescopic pipe (4) and the attachments
Attach the telescopic extension pipe (4) to the flexible hose handle (5)
Extend the lower part of the telescopic extension pipe (4) to the required length, having preliminarily pressed the lock (3)
Choose the necessary attachment: floor/carpet brush (1), combined crevice nozzle (26) or parquet/laminate floor attachment (27) – and attach it to the telescopic extension pipe (4).
You can attach the combined crevice nozzle (26) to the flexible hose handle (5).

ATTENTION!

Do not use the vacuum cleaner in places where aerosols are used or sprayed and in proximity to highly inflammable liquids, do not use the vacuum cleaner in the places where such liquids are stored.
The vacuum cleaner is not intended for collecting water or any other liquids; do not use it for collecting burning or smoking cigarettes or cinders.
Do not use the vacuum cleaner for collecting dust of plaster, concrete, flour or ashes.
Take sharp objects away from the floor before cleaning to prevent damage to the unit.
If the suction power of the vacuum cleaner decreases rapidly while cleaning, switch it off immediately, unplug it and check the telescopic pipe (4) or the flexible hose (7) for obstruction. Remove the obstruction, after that you can resume cleaning

USING THE VACUUM CLEANER

The dust bin (11) is equipped with the cyclonic filter (20) which sieves out garbage and dust from the ingoing air, and the inlet HEPA (19) filter fully retains the finest dust particles.

Note : provide that the HEPA filter (19) is always clean, because the overall performance of the vacuum cleaner depends on it.

Attention!

Before switching on and using the vacuum cleaner, make sure that the HEPA filter (19), the separator (20), the dust bin (11) and the outlet filter (17) are installed properly.
Take the power plug and unwind the power cord to the required length, connect the power plug to the mains socket.
The yellow mark on the power cord indicates the maximum cord length. Do not pull out the power cord further than the red mark.
Press the on/off button (16) to switch the vacuum cleaner on.
While cleaning, you can control the suction power using the manual suction power control (6) on the flexible hose handle (5)
After you finish cleaning, switch the vacuum cleaner off by pressing the on/off button (16) and unplug it.
• To wind the power cord, press the button (14); keep a hold of the winding cord with your hand. pressing the on/off button (16) and unplug it.

CLEANING AND MAINTENANCE

Cleaning the dust bin (11)
It is recommended to remove garbage and dust from the dust bin (11) after every room cleaning.
Switch the vacuum cleaner off by pressing the on/off button (16) and unplug it.
Holding the handle (12), press the lock (13) and remove the dust bin (11) .
Place the dust bin (11) over a garbage bin.
Pull the lock (24) and open the lower lid (25)
Remove accumulated dust and garbage from dust bin (11).
Close the lid (25).
Install the dust bin (11) back to its place and make sure that the dust bin (11) is fixed properly.
Cleaning the HEPA filter (19) and the separator (20) installed in the dust bin (11)
Preliminarily remove dust and garbage from the dust bin (11) as described above
Pull the lock (21) of the upper lid (22) and open the lid (22)
Remove the separator (20) (pic. 7), turn the HEPA filter (19) clockwise and remove it
Remove dust and garbage from the separator (20)
Wash the separator (19) under a warm water jet and then dry it.
Wash the HEPA filter (19) under a warm water jet and dry it
Do not wash the parts in a dishwashing machine.
Dry the HEPA filter (19) thoroughly.
Do not dry the HEPA filter (19) with a hairdryer or similar appliances.
Wash the dust bin flask (23), wipe it and dry.
Install the HEPA filter (19) in the separator (20) and turn it counterclockwise as far as it will go.
Insert the separator (20) into the flask (23).
Close the lid (22) until the lock (21) catches.
Install the assembled dust bin (11) back to its place, make sure that the dust bin (11) is fixed properly

Cleaning the outlet filter (17)

Switch the vacuum cleaner off and unplug the power cord plug from the mains socket.
Remove the outlet filter grid (18), turning it clockwise and remove the outlet filter (17)
Wash the outlet filter (17) and the grid (18) under a lukewarm water jet. Do not wash the outlet filter (17) and the grid (18) in a dishwashing machine.
Dry the outlet filter (17) and the grid (18).
Install the outlet filter (17) back to its place.
Install the grid (18) back to its place, turn the grid (18) counterclockwise as far as it will go.

Vacuum cleaner body

Clean the vacuum cleaner body with a soft, slightly damp cloth, and then wipe it dry. Provide that no liquid gets inside the vacuum cleaner body.
Do not use solvents or abrasives for cleaning the vacuum cleaner body and the attachments.
Do not immerse the vacuum cleaner body, the power cord and the power plug into water or any other liquids.

OVERHEATING PROTECTION

If the electric motor gets too hot during the operation, the overheating protection system will be set off.
If during cleaning the vacuum cleaner has switched off, press the on/off button (16) and unplug the unit.
Let the vacuum cleaner cool down for 30-40 minutes and switch it on again. The cool-down time can differ from the given value, depending on the room temperature.

STORAGE

Before taking the vacuum cleaner away for long storage, clean the unit body, the dust bin (11), the
HEPA filter (19), the separator (20), the dust bin flask (23) and the outlet filter (17).
For easy storing of the vacuum cleaner, use the brush storage (15) (pic. 4).
Keep the vacuum cleaner in a dry cool place out of reach of children and disabled persons.

DELIVERY SET

Vacuum cleaner with the dust bin and filters installed – 1 pc.
Flexible hose – 1 pc.
Telescopic extension pipe – 1 pc.
Floor/carpet brush – 1 pc.
Combined crevice nozzle – 1 pc.
Furniture/furniture upholstery brush – 1 pc.
Instruction manual – 1 pc.

SPECIFICATIONS

Power supply: 220-240 V ~ 50 Hz
Rated input power: 1800 W
Suction power: 400 W

RECYCLING
To prevent possible damage to the environment or harm to the health of people by uncontrolled waste disposal, after expiration of the service life of the unit or the batteries (if included), do not discard them with usual household waste, but take the unit and the batteries to specialized stations for further recycling. The waste generated during the recycling of the unit is subject to mandatory collection and consequent recycling in the prescribed manner. For further information about recycling of this product, apply to the local municipal administration, a household waste recycling service or to the shop where you purchased this product

The unit operating life is 3 years
The manufacturing date is specified in the serial number. In case of any malfunctions, promptly apply to the authorized service center.