Knightsbridge TRIBCCW Brushed Chrome 2W 140lm 4000K 128mm Triangular LED Under Cabinet Light Instruction Manual
- June 9, 2024
- Knightsbridge
Table of Contents
Knightsbridge TRIBCCW Brushed Chrome 2W 140lm 4000K 128mm Triangular LED
Under Cabinet Light
GENERAL INSTRUCTIONS
These instructions should be read carefully and retained after installation by
the end user for future reference and maintenance.
These instructions should be used to aid installation of the following
products:
TRIBCCW / TRIBCWW
SAFETY
- This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
- Please isolate mains prior to installation or maintenance
- Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the circuit cable, fuse, or circuit breaker
- Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for installation
- This product is for indoor use only
- This product is Class I and must be earthed
- This product series is IP20 rated
INSTALLATION
Note – If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the manufacturer of the sensors that they are compatible with LED luminaires.
- Provide power to the required point of installation
- Remove the lamp housing from the triangular body by pressing from the rear
- Using the triangular body as a template, mark the location for, and drill the fixing holes ensuring not to infringe with any gas/water pipes or electrical cables
- Fix the base to a suitable solid surface using the screw provided
- Connect the luminaire to the mains supply ensuring the correct polarity is observed: L – Live (brown), E – Earth (green/yellow), N – Neutral (blue)
- Reattach the lamp housing to the triangular body
- Switch on and check for correct operation
WARNING
This luminaire must be disconnected from the circuit if subjected to any high
voltage or insulation resistance testing. Irreparable damage will occur if
this instruction is not followed.
GENERAL
This product contains a light source of energy efficiency class F to
Regulation (EU) No. 2019/2015 and (UK) 2021 No. 1095.
This product contains an LED light source and control gear which can be
replaced by a professional.
Clean with a soft dry cloth only, do not use aggressive cleaning products or
solvents which may damage the product.
This product is non-dimmable.
The external supply cable of this luminaire cannot be replaced; if the cable
is damaged, the luminaire should be destroyed.
This product should be dismantled for disposal when it reaches the end of its
life. Please see website for dismantling instructions.
This product should be recycled in the correct manner when it reaches the end
of its life. Check local authorities for where facilities exist.
WARRANTY
This product has a warranty of 3 years from date of purchase. Failure to install this product in accordance with the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve the right to alter product specification without prior notice.
SUPPLIED BY:
(UK) MANUFACTURER ML ACCESSORIES LTD,UNIT E CHILTERN PARK, BOSCOMBE
ROAD,DUNSTABLE LU5 4LT,
WWW.MLACCESSORIES.CO.UK
(EU) AUTHORISED REPRESENTATIVE
NNUKS HOLDING GMBH,NIEDERKASSELER LOHWEG 18,40547 DÜSSELDORF, GERMANY,EMAIL:
EPREL@NNUKS.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>