Ruijie Reyee Wi-Fi 5 Wall Mounted Access Point Installation Guide
- June 9, 2024
- RuiJie
Table of Contents
Ruijie Reyee Wi-Fi 5 Wall Mounted Access Point Installation Guide
Packing List
Item
| Name| Quantity|
Unit
---|---|---|---
1| RG-RAP1200(P)Host| 1| Set
2|
This Quick Installation Guide
| 1| Copy
3| Warranty card| 1| Copy
4| Mounting Screw
| 2| Piece
Appearance and Interface
Top view
Note: 1 Reset button
2 LAN/PoE-Out Port
Rear View
Note: WAN/PoE Port
Note:
- When powering the AP through PoE, connect one end of the Ethernet cable to the WAN/PoE port and the other end to a PoE-capable device.
- With IEEE 802.3at PoE+ input, the PoE-OUT port supports up to 15.4W output power to the external terminals complying with IEEE 802.3af.
LED Indicator and button
| LED Indicator and Button | Frequency | Description |
|---|---|---|
| LED Indicator | Solid green | Normal operation |
| Off | Normal operation, but the AP is not connected to Ruijie Cloud. | |
| Blinking(0.5Hz) | Possible cases: |
- Restoring the factory default settings
- Upgrading the firmware
- Restoring the image file
- .Initializing the device
- Overload of the PoE-Out port
Press for less than 2 seconds| Restart the device.
Reset Button| Press for more than 5 seconds| Restore the factory settings.
Product Installation
-
Loosen screws on the 86-type faceplate that is mounted on the wall.
-
Connect the Ethernet cable to the WAN/PoE port.
-
Align screw holes on both sides of the device over those on the faceplate. And then tighten screws with a screwdriver.
-
Install the plate cover in the way as shown in the figure.
Note:
You need to buy the mounting bracket, if you mount the AP on a single-gang
wall junction box compliant with US standards.
Network Configuration
Method 1 (Recommended)
Scan the QR-code on the manual or device to download Ruijie Cloud App. Follow
the guide on App to set up and configure the network.
Method 2
Connect to the device SSID (@Ruijie-mxxxx when there are multiple devices
and @Ruijie-sxxxx default when there is only one device), or connect the cable
with LAN port and visit http://10.44.77.253 (default password:admin). It is
recommend to configure the IP address of PC as 10.44.77.250.
Note:
This equipment is restricted to indoor operation in 5.15-5.25GHz for Hong
Kong.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>