Ruijie Reyee RG-EW3200GX Pro Wi-Fi 6 Dual-band Gigabit Mesh Router User Guide
- June 3, 2024
- Ruijie Reyee
Table of Contents
Ruijie Reyee RG-EW3200GX Pro Wi-Fi 6 Dual-band Gigabit Mesh Router User
Guide
Appearance
Please connect the power and network cables as shown below.
Indicator
Reyee Mesh Indicator
Green| Blinking| The device is being paired.
Steady on| The device is paired and Wi-Fi signal is normal.
Orange| Steady on| The device is paired but Wi-Fi signal is weak.
Red| Steady on| The device pairing is disconnected.
System Status Indicator
Blue| Steady on| The device is running normally.
Blinking| Restoring the factory settings or restarting
Network Connection
Scenario 1: Configure a single router
After you connect the cable and power the router on, it will start up in 2 to 3 minutes. Wait until the system status indicator turns into steady blue and the router broadcasts the SSID (@Ruijie-sXXXX by default).
Please follow the steps:
-
Connect to the SSID @Ruijie-sXXXX, and the configuration page will be displayed automatically; if not, please visit 192.168.110.1.
-
The router will check the Internet access method. Please configure the network parameters accordingly.
-
Configure the SSID and password. After the configuration works, you can connect to the SSID and access the Internet.
Scenario 2: Reyee Mesh
-
Place the second router within 2 meters of the first one, and power it on.
After the system status indicator blinks in blue, wait for 2 to 3 minutes until it turns into steady blue. (If the router has been configured before, please press the Reset Button for more than 3 seconds to restore the factory settings). Reset Instructions -
Press the Reyee Mesh button on the first router.
Press the Reyee Mesh button on the first router, and its indicator will blink in green during searching for routers. The indicator on the second router will also blink in green slowly during paring. After 2 minutes, as the indicators on both routers turn into steady green, the pairing succeeds.
-
Place the second router to the specified position and power it on.
After powering the router, wait for 3 to 5 minutes until the Reyee Mesh indicator turns into steady blue, it is all set and you can access the Internet. The meshed routers will share the same SSID and password. Visit 192.168.110.1 to check router connecting condition.
If there is any network port available, you can connect cables as shown below. The wired connection is more stable.
- Please note that Wi-Fi signal may be weak if two routers are placed far from each other or there are several obstacles like wall ls between them.
- The Internet speed may be slow if there are multiple paired routers. We recommended mesh-up within 5 routers (1+4) to keep good performance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>