marta MT-CH2452A Convection Heater User Manual

June 9, 2024
MARTA

marta MT-CH2452A Convection Heater

marta MT-CH2452A-Convection-Heater-FIG- \(2\)

Description

marta MT-CH2452A-Convection-Heater-FIG-
\(3\)

  1. Thermostat knob
  2. Indicator light
  3. Heating mode switch
  4. Air outlet
  5. Feet

Real set of the appliance could be different from listed in the User manual. Check once buy.

ASSEMBLY

marta MT-CH2452A-Convection-Heater-FIG-
\(4\)

If the appliance is to be used on a floor, attach the wheels to the supports before use, then screw the feet to the base of the heater with 4 screws (supplied). Make sure they are located in the base holes provided for this purpose.

Attention:

  • According to fire safety requirements, the distance between the lower part of the heater and the floor, as well as the upper part and the window sill, must be at least 15 cm, and not less than 1 meters from the heater to curtains, furniture and other items.
  • Do not mount the appliance directly above or below an electrical outlet. Before installation, make sure that there are no electrical wiring, water pipes, etc. in the wall.
  • When mounting the appliance on a wall, the feet must be removed.

marta MT-CH2452A-Convection-Heater-FIG- \(5\)

  1. Wall mounts
  2. Rubber stops
  3. A) Measure the distance between the places to install the brackets for the wall mounting on the rear panel of the heater (1). Determine the height you need fix the heater.
  4. B) Drill two holes of suitable diameter and depth in the wall so that the distances between them coincided with the distances between the place for the brackets on rear panel of the heater. Insert the dowels into the holes made.
  5. C) Attach the two top brackets to the wall.
  6. D) Before fixing the heater to the wall, fix the rubber stops (2) on the rear device panel.
  7. E) Hold the heater and hang it on the brackets fixed on the wall.
  8. F) Fix the fixing tabs with screws (indicated by an arrow in the figure).

CAUTION

When using any electrical appliance, basic safety precautions should always be followed, including the following: To ensure familiarity with the controls, safety features, and operation of your heater, read all instructions before use.

  • Danger of electric shock exists even when the appliance is switched off. ALWAYS unplug the unit when not in use.
  • Unplug heater by grasping plug and pulling it from the outlet. NEVER YANK ON CORD. Do not insert and pull out the plug by wet hands, as this may cause electrical shock.
  • Heater should never be used under conditions where it may be immersed, or come in contact with water. Similarly do not plug in your heater if its surfaces are damp.
  • Do not operate the heater with a damaged cord set, or if it has been dropped, or damaged in any manner. Return it to an Authorized Service center for inspection, repairing and testing.
  • Do not use outdoors. Do not leave the cable on hot surfaces.
  • Disconnect the cord from the outlet before cleaning. When store your heater, keep it in a cool, dry place.
  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Close supervision is required when any appliance is used by or near children.
  • The surface temperature of the flanges is higher, during use, thus closely supervise any children in the area of this appliance.
  • If malfunctions happen during operation, please put it to nearby appointed service center with the maintenance card. Never disassemble it by yourself.
  • To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
  • The heater must always operate in vertical position.
  • Do not scrap the surface with rod or sharp hard tools, as this may cause deformation and rust because of damage of paint coat.
  • During use surface temperature of the flanges is perhaps higher, thus do not touch it except handle, knob and the keys.
  • Never use the unit in places with not flat and unstable surfaces. Make sure there are no flammable or easy deformed objects within 1m.
  • The heater is suitable for operation on an A.C. electricity supply having the same voltage as that shown on its rating label. The unit should be earthed.
  • Do not cover the appliance. CAUTION! Do not cover the heater while it is on. This can cause dangerous temperature increase.

BEFORE THE FIRST USE

  • Unpack the appliance and remove all packaging materials and labels. Store warning labels (if available) and the product serial number plate on the housing!
  • Clean the device with a damp cloth, clean the accessories in soapy water rinse thoroughly and dry.
  • To avoid damage to the unit, nothing should prevent the air vent system from functioning.

CLEANING AND MAINTENANCE

  • Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
  • Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
  • Do not use any detergents or abrasives and do not allow any water to enter the heater.
  • When the heater is not used for long periods, it should be protected from dust and stored in a clean dry place

SPECIFICATION

Power supply| Model| Max Power, W| Net weight / Gross weight, kg| Package size (L х W х H), mm| Recommended room space, m²
---|---|---|---|---|---

230 V, 50 Hz

| MT-CH2452A| 1000-1200| 3,1 / 3,8| 505x120x505| ≤ 15
MT-CH2452B| 1500-1800| 4,0 / 4,8| 655x120x505| ≤ 20
MT-CH2452C| 2000-2400| 4,3 / 5,3| 815x120x505| ≤ 25
MT-CH2452D| 2500-3000| 4,4 / 5,4| 815x120x505| ≤ 30

Producer : Cosmos Far View International Limited. Room 701, 16 apt, Lane 165, Rainbow North Street, Ningbo, China. Made in China

WARRANTY

WARRANTY DOES NOT COVER SUPPLIES

(filters, ceramic and non-stick coating, rubber seals, etc.)
Production date is available in the serial number located on the identification sticker on the gift box and/or on sticker on the device. The serial number consists of 13 characters, the 4th and 5th characters indicate the month, the 6th and 7th indicate the year of device production.
Producer may change the complete set, appearance, country of manufacture, warranty and technical characteristics of the model without notice. Please check when purchasing device.
Current information about service centers is available on the website www.multimarta.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals