WASSERSTEIN Floodlight No Drill Munt User Manual

June 9, 2024
WASSERSTEIN

Floodlight
No-Drill Mount
USER MANUAL

In the Box

WASSERSTEIN Floodlight No Drill Munt - fig 1

Applications

This mount sticks to most smooth surfaces, such as tile, marble, metal, plastic, and wood.

Warning!

  • Read this manual and instructions carefully before use. Failure to follow the safety instructions may cause injury or damage to your property.
  • Do not stick to brick, stucco, or wall paper.
  • Extreme weather condition can shorten the life of the mounting tape and your camera, beware when mounting it outdoor.
  • Do not hang the floodlight on the mount immediately, wait for at least 24 hrs before installing the floodlight.
  • It is not recommended to mount the floodlight above a pathway or door where people will be under.
  • The surface can be damaged when removing the mount from the wall.

Compatibility

Blink Floodlight Mount

Installation

  1. Check the view and test the trigger event from the Blink app before installing.

  2. Make sure the surface you want to apply the mount to is smooth, dry, and clean.

  3. Remove the protective film from the mounting tape without touching the adhesive.
    Note: For best results, the tape should be applied at a minimum temperature of 60°F (15°C).WASSERSTEIN Floodlight No Drill Munt - fig
1

  4. Carefully attach the mount to the surface in one go. Press and hold for 30 seconds to ensure maximum adhesion.WASSERSTEIN Floodlight No Drill Munt - fig 3

  5. Wait for 24 hrs for the adhesive to fully dry.

  6. Slide the floodlight onto the mount until it clicks.WASSERSTEIN Floodlight No Drill Munt - fig4

  7. To remove the floodlight, press the tab on the mount down and slide the floodlight to the right.WASSERSTEIN Floodlight No Drill Munt - fig 5

Removing The Mount

  1. To remove the mount, remove the floodlight from the mount.
  2. Slowly twist and pull the mount at the same time. Gently lift it up to prevent damage to the wall (use a hairdryer for easier removal).
  3. Remove the tape by pulling it downwards. Wipe off any leftover residue.
  4. Make sure to remove all the old adhesive before applying the new one.

Contact Us

Scan the QR code below or email us at contact@wasserstein- home.com

Blink Floodlight Mount and Camera are not included.
Wasserstein is a trademark of Dropcases Ltd.
Wasserstein is not affiliated with Immedia Semiconductor, LLC
Blink is the trademark of Immedia Semiconductor, LLC
www.wasserstein-home.com
Made in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals