PHILIPS PDRAS Room Automation System Installation Guide
- June 9, 2024
- Philips
Table of Contents
PHILIPS PDRAS Room Automation System Installation Guide
Installation Instructions
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
ASSEMBLY INSTRUCTION
PRODUCT DIMENSION
INSTALLATION INSTRUCTION
Supply input
Supply input must be protected with external 120V/15A circuit breaker
Output Ratings/Channel (CH)
| Load Type | CH1-CH5 |
|---|---|
| General Use | 16 A, 277 V |
Incandescent
Standard Ballast
Electronic Ballast
M Motor| 16 FLA (1 HP), 120 V 14.5 FLA (2 1 /2 HP), 240 V 14.1 FLA (3
HP), 277 V
Pilot Duty| 6 A, 120 V 3 A, 240 V 2.6 A, 277 V
Control Channel Ratings
DALI Addressable and Broadcast| ≤ 10/CH Guaranteed 20 mA Maximum 250 mA
Insulation: basic| ≤ 50
DSI| ≤ 10/CH| ≤ 50
1-10 V| Sink 10 mA Source 10 mA| Driver dependent
Output Ratings/Group
CH-CH ≤ 300 V (UL)/400 V (CE) DDBC516FR ≤ 80 A
Only one ultrasonic sensor per room
Sensor placement depends on local architecture
Outputs configured for 1-10 V control
Only one ultrasonic sensor per room
Sensor placement depends on local architecture
Outputs configured for 1-10 V control
Outputs configured for 1-10 V control
Federal Communications Commission (FCC) Compliance Notice: Radio Frequency
Notice –
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. Consult the dealer or an experienced radio/TV
technician for help. Any modifications not approved by the manufacturer of
this device could void the user’s authority to operate this device
****This Class B digital apparatus complies with Canadian ICES-003: CAN ICES-3(B)/NMB-3(B). Cet appareil numerique de la classe B est conforme a la norme NMB003 du Canada: CAN ICES-3(B)/NMB-3(B).
****Suitable for plenum install per NEC 300.22(C)(3).
© 2022 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective www.dynalite.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>