KYOCERA ECOSYS PA6000x Fairbanks Printers User Guide

KYOCERA ECOSYS PA6000x Fairbanks Printers

Installation Environment

Kyocera Recommends selecting the Location for the printer as follows:

1. Room Temperature range: 50 to 90.5°F
2. Humidity Level: 10 to 80%
3. Power: Avoid the following locations when selecting a site for the machine. Adverse environmental conditions may affect the image quality.
   + Avoid locations near a window or with exposure to direct sunlight.
   + Avoid locations with vibrations.
   + Avoid locations with rapid temperature fluctuations.
   + Avoid locations with direct exposure to hot or cold air.
   + Avoid poorly ventilated locations.

Recommended Installation Space

*1: The value when an optional rear tray (PT-320) is installed to the the ECOSYS PA5000x, ECOSYS PA5500x and ECOSYS PA6000.

Step 1 Setting up the Printer

1. Open the Box. Remove the machine carefully from the box grasping both sides.

2. Lift the main unit from the handles by cardboard handles.
   

3. Open the top cover. After Removing the packing material, shake and install the toner container. Close the top cover.
   
   
   

Step 2 Install Waste toner box

Step 3 Loading Paper

1. Pull the Cassette 1 completely out of the machine.
   

2. Adjust the paper length and width guide to the paper size required.
   

3. Fan the paper, then tap it on a level surface.

4. Load paper.

5. Gently push the Cassette 1 back in.
   
   + Set print side face-up.
   + No bent or folder edges in the paper. Such paper may cause paper jams.
   + Set the quantity of the paper less than the maximum paper indication on the side or the cassette.
   + If the paper is loaded without adjusting the paper length guide and the pa per width guides, skewed paper feeding, and a paper jam will occur.

Step 4 Powering on the Printer

1. Connect the power cord to the rear of the machine and the
   

2. Turn the power switch ON at the front of the printer. other end to the power outlet.
   

Step 5 Default Settings of the Machine

1. Press [◀] [▶] key to select default language > [OK] key.
   

2. Select [Yes].
   
   The setup screen appears.

3. Select [Change] when you change the time zone, date and time. Follow the instructions on the screen. If not, select [Skip].
   
   The screen moves to the next step.

4. Select [Change] when you set the IP address to use the machine on the network. Follow the instructions on the screen. If you set it later, select [Skip].
   
   The screen moves to the next setp.
   NOTE Prepare the device and information according to the your environment. For details of the network settings, refer to the Operation Guide.

5. Select [Change] when you set whether  notify low toner via panel or not.If you set it later, select [Skip].
   

6. When the following screen appears, select [Finish].
   

Step 6 Printing a Status Page

1. [Menu] key > [▲] [▼] key > [Report] > [OK] key > [▲] [▼] key > [Report Print] > [OK] key
   

2. [▲] [▼] key > [Status Page] > [OK] key > [Yes]

Step 7 Installing Software

Access the following URL and select your model and OS. Download Center: https://kyocera.inf

For Windows Download and run the Web Installer and follow the on-screen instructions to install the driver and software.

For Mac Download and run the driver and follow the on-screen instructions to install.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>