MyTana MV84 Antifreeze Kit Instructions
- June 9, 2024
- MyTana
Table of Contents
MyTana MV84 Antifreeze Kit
Introduction
If you know there will be a period of several days when the jetter will be idle OR if the jetter is stored in potentially freezing weather, be sure to run antifreeze into pump and it’s hoses as part of your shutdown procedure. We recommend using RV antifreeze. This Kit is compatible for use with MyTana MV80 or MV84 jetters
SET UP
- Drain all water out of the buffer tank, completely, and close the drain valve.
- Attach the Antifreeze Kit hose to the jetter
- Pour enough antifreeze into the tank to cover the strainer. If the strainer is not covered, air will get into the pump and cause damage.
PROCEDURE
- Start up the motor, and throttle to high.
- With the ball valve on the hose open, run until the antifreeze comes out of the float valve.
- Turn the ball valve clockwise 90°.
- Run until antifreeze comes out of the bypass hose.
FINISH UP
- Throttle down and shut off the motor.
- Turn the ball valve back 90° to relieve trapped line pressure.
- Drain the antifreeze from the tank by opening the tank drain ball valve. Capture the antifreeze for re-use by either
NEED HELP
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>