KERN YKUP-01 Interface Adapter with Cable User Manual
- June 8, 2024
- KERN
Table of Contents
YKUP-01 Interface Adapter with Cable
User Manual
YKUP-01 Interface Adapter with Cable
Type TYKUP-01-A
Version 1.0 2021-09 GB
**** You will find the current version of these instructions also online
under: https://www.kern-sohn.com/shop/de/DOWNLOADS/ Under the column Operating instructions
General hints
Cable length : 1.5 m
- **** Via the interfaces weighing data may be exchanged with connected peripheral devices.
- Issue may be made to a printer, PC or control displays. Control commands and data input may also occur at reverse order via the connected devices.
- Only KERN KUP adapters may be connected to the 15-pol-sub-Dplug of the device!
1.1 Installation
- Switch off the balance
- Plug in the KUP adapter (RS232) at the 15-pol-sub-D-plug of the device
- Switch on device
- The KUP adapter is automatically recognised by the appliance
1.1.1 Allocation of connections KUP adapter:
Sub-D bushing 9 pol. (bushing = to balance)
| Pin 1| VB
Pin 2| TXD (RS232)
Pin 3| RXD (RS232)
Pin 4| VCC
Pin 5| Signal ground (RS232)
Pin 6| Low Signal (signal light for Checkweighing)
Pin 7| Hi Signal (signal light for Checkweighing)
Pin 8| OK Signal (signal light for Checkweighing)
Pin 9| No assignment
1.1.2 Setting communication parameters:
** The communication parameters (baud rate, bits and parity) of balance
and printer/PC must match.
KERN standard settings (factory setting):**
- baud 9600
- 8 data bit
- 1 stop bit
- No parity
KERN & Sohn GmbH
Ziegelei 1 72336 Balingen-Frommern Germany
+0049-[0]7433-9933-0
+0049-[0]7433-9933-149
info@kern-sohn.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>