ROCCAT Kone Pro Gaming Mouse User Guide
- June 5, 2024
- ROCCAT
Table of Contents
QUICK START
GUIDE
PACKAGE CONTAINS
* Please remove
the blue protection film from the mouse feet before use
DEFAULT BUTTON ASSIGNMENT
(no driver installed)
STANDARD
- = Left mouse button
- = Right mouse button
- = Universal scroll
- = Scroll up
- = Scroll down
- = IE Forward
- = IE Backward
- = Profile cycle button
INSTRUCTIONS
- Plug the USB connector into any free USB port on your PC or laptop.
- Navigate to www.roccat.com/downloads and download the latest driver.
- Complete the installation to get access to all software features and setup.
Disposal information
The crossed-out wheelie-bin symbol means that you must not dispose of this
product together with unsorted household waste. As electrical devices can
contain harmful substances which may cause environmental damage or harm to
your health if not disposed of correctly, please dispose of these products
separately. As the end-user, you are required by law to dispose of used
electrical equipment at an official recycling point. For information about
local recycling points, contact your local authority, civic amenity site or
the business where you purchased this product. By disposing of electrical
products at an official recycling point, you are doing your bit to ensure
equipment is recycled correctly and professionally, and our environment is
protected. When purchasing a new product, the retailer will let you hand in
old products and dispose of them free of charge provided the product you are
handing in is of a similar type and has the same functions as the product you
are purchasing. You can hand in small used electrical and electronic equipment
(measuring no longer than 25 cm on any one side) for free and with no
obligation to purchase a similar product at electrical and electronic retail
outlets with sales areas larger than 400m² or at nearby recycling points
designated by the retail outlet. Wherever possible, remove any batteries
before disposing of the device. Under the law, as a user, you face the risk of
penalties if you dispose of devices and batteries illegally.
Technical support
Have technical problems with this product? Get in touch with our Support team
– the quickest way is via our website:
www.roccat.com/support Please keep this
information for later reference.
TECHNICAL FACTS
- TECH SPECS KONE PRO ROCCAT® Owl-Eye 19K dpi optical sensor (based on PixArt PAW3370)
- 400 IPS (10.2m/s) maximum speed
- 50g maximum acceleration (stop to maximum speed in 0.03s required to reach limit)
- Default DPI steps: 400, 800 (default), 1200, 1600, 3200 1.8m Phantom Flex™ cable length
- 1000Hz polling rate
- Lift-off distance: 1mm, 2mm, and surface calibration
- ARM32 M0+ MCU
- On-board memory
- ROCCAT® Titan Switch Optical, 100 million click life-cycle
- 66g weight
Should you need assistance …
Our support team is ready to help you with any technical questions. Just send
an e-mail to support@roccat.com or visit our
website at: WWW.ROCCAT.COM/SUPPORT
SYSTEM REQUIREMENTS
- Windows® 7, 8, and 10 (software support)
- USB 2.0 (or higher)
- Internet connection (for driver software)
DRIVERLESS SETUP
Press the profile button in combination with the left mouse button for three seconds to enter config mode. The mouse will blink in the color of the active profile. To exit config mode, press the profile button in combination with the left mouse button for three seconds once more. Scroll up/scroll down: Change the DPI level from 5 available presets. LEDs will fade into one of the colors listed below to reflect the chosen DPI preset.
- 400 DPI – red
- 800 DPI – green
- 1200 DPI – cyan
- 1600 – blue
- 3200 – pink
Forward side button/backward side button: Change polling rate. The right mouse button will blink in one of the colors listed below to reflect the chosen polling rate.
- 125Hz – blue
- 250Hz – green
- 500Hz – yellow
- 1000Hz – white (default)
Wheel click: Swap between 1mm and 2mm lift-off distance. The left mouse button will blink in one of the colors listed below to reflect the chosen lift-off distance.
- 1mm – red
- 2mm – green
While holding the left mouse button, press the forward side button/backward side button: Change LED brightness in steps of 10%. While holding the right mouse button, press the forward side button/backward side button: Change between Static, Wave, Heartbeat, Breathing, or Blinking RGB modes. The effect is immediately shown on the mouse. While holding the left or right mouse buttons and wheel up/down: Change the color of the LEDs corresponding to the button held from 16 presets. When both are held at the same time it changes both at once. Changes are immediately shown on the mouse.
FCC CAUTION:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received,
including interference that may cause undesired operation
GENERAL SAFETY GUIDELINES AND INTENDED USE
- Do not open or modify the product.
- Not approved changes or modifications may void the operation authority and/or warranty.
- In case of trouble or doubt, contact us immediately.
- Keep the product away from fire/water/humidity/temperature extremes.
- Only use as intended with a compliant PC and connector part.
- Improper or incorrect use of the product or use of the product for purposes not recommended by the manufacturer void the liability and/or warranty.
- Don‘t look into the light beam on the bottom of the mouse.
Hereby, Voyetra Turtle Beach Corp. declares that this product is in compliance
with the essential requirements and other relevant provisions of Directive
2014/30/EU. The full Declaration of Conformity can be requested via the
following:
Company: Voyetra Turtle Beach, Inc.
Address: 44 South Broadway, 4th Floor, White Plains NY 10601, USA
E-Mail: support@roccat.com
VOYETRA TURTLE BEACH, INC. | 44 SOUTH BROADWAY, 4TH FLOOR, WHITE PLAINS NY 10601, USA
© 2022 Voyetra Turtle Beach, Inc. All rights reserved. Any product names mentioned in this manual may be trademarks or registered trademarks and are the property of their respective owners. Information contained herein is subject to change without notice. Voyetra Turtle Beach, Inc. shall not be made liable for any errors that may appear in this manual. This publication or parts of it may not be reproduced without the express consent of the publisher. ROCCAT® is a Turtle Beach Brand.
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and for compensation for any other reasonably foreseeable loss or damage. You
are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
BSMI https://www.roccat-neon.com/Bsmi
Join the community
Become a ROCCAT member and register your product at: www.roccat.com/support
/register-your-product
Service & support
Easy access to
customer support
Authenticity check
Make sure you
own an original
Exclusive deals
Opt-in for special
offers and downloads
Please use your product’s serial number
(located on the bottom label)
WWW.ROCCAT.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>