BOCCI 84.6V Floor Lamp Instructions
- June 8, 2024
- BOCCI
Table of Contents
BOCCI 84.6V Floor Lamp
DIMENSION
SPECIFICATION
- PENDANTS: six
- LAMPING: 1.5w LED
- POLE LENGTH: 2.4m (8’) / 2.7m (9’) /3m (10’)
- MATERIALS: blown glass, black flexible cord, brass dial control, unlacquered brass or black powder coated stem
- ADDITIONAL
- EXTENDERS: 153mm (6”) / 305mm (12”)
- WEIGHT: approximately 15kg (33.3lb) / 15.5kg (34.2lb) / 16kg (35lb)
- CABLE LENGTH: 2290mm (90”) flexible cable
- POWER SUPPLIES: integral
DESCRIPTION
The stem column system comes in unlacquered brass or black powder coated stem.
It comes with a 2290mm (90”) long flexible cable with dial control for
on/off/dimming. There is notch on the back of the dial control for wall
mounting.
A white glass bubble is captured inside a fine copper mesh basket and then
plunged into hot clear glass. Air is blown into the matrix to gently push the
white glass through the mesh, creating a delicate pillowed form that is
suspended inside the thick outer layer of clear glass. Sometimes the copper
mesh basket folds and crinkles, adding specificity to each piece.
NOTES
- Purchase replacement lamps online at www.bocci.com/shop/bulbs
- Details on minimum/maximum height, please see column configurations diagram on the last page of this document.
- The brass used in our Stem Series is untreated and, as such, will develop a natural patina over time. To avoid any marking or tarnish on the brass during handling and installation, please use the gloves provided in your shipment.
- To maintain your fixture, please regularly dust with a lint-free cloth. If further cleaning is required, dampen a lint-free cloth with water only and wipe gently to remove dust or debris.
-
Thread the stem spikes onto the assembled stem on both ends. Connect the rest of the pieces with the stem connector.
Note: This step is only necessary for 2.7m (9’) and 3m (10’) stem options.
Note: Bocci recommends wearing thin gloves during installation to protect the stem finish and the glass surface. -
Thread the pendant mounting plate onto the stem. Carefully insert provided lamp into socket.
-
Plug in the cord to the plug head. Plug in light. Turn the dial to check power to lamp is working correctly.
-
Gently thread pendant onto the stem. Be sure to carefully place the pendant so as not to damage the lamp during installation. Clean fingerprints.
-
There are 2 x stem holders. Install one to the ceiling and one to the floor. You must secure the ceiling stem holder with provided screws.
- Peal off the adhesive silicone pad and attach to the holder base.
- Position the stem holder to the ceiling and secure with screws.
Repeat steps for the
floor stem holder. Bocci recommends securing the floor stem holder to the floor for additional support.
-
The end opposite to the cord has a spring loaded spike. Unthread the spike to add or remove springs to adjust tension or range to the fixture.
-
Push this end into the stem holder. The spike must rest inside the indentation. Position the opposite end to the stem holder that is located on the floor. Clean fingerprints from fixture surfaces.
BRASS COLUMN
This diagram is meant to illustrate the extender combinations for the columnar stem fixtures.
COLUMN CONF IGUR ATIONS PRODUCT INSTALLATION INSTRUCTIONS
© 2021, Bocci Design and Manufacturing Inc. All rights reserved. Any inquiries
should be directed to: info@bocci.com
For additional assistance, please contact Bocci:
sales@bocci.com
www.bocci.com
europe@bocci.com
www.bocci.com
US Patent Pending
EU Patent # 003611144-0001 to 0004
Made in Vancouver, Canada
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>