FSDH-TOPKT-4-DD Furniture Sliding Barn Door Hardware Kit Installation Guide
- June 8, 2024
- FURNITURE
Table of Contents
MODEL No.
*FSDH-TOPKT--4-DD
Installation Guide**
TOOLS REQUIRED
• Plumb Line
• Pencil
• Phillips Head Screwdriver
• 4mm Drill Bit| • Wrench
• Level
• Power Drill
• Tape Measure
---|---
INCLUDED IN KIT
| A | Door Roller Hardware | x4 |
|---|---|---|
| B | Anti-Jump Disk | x4 |
| C | Door Stop Hardware | x2 |
| D | End Cap | x2 |
| E | Mounting Bracket for ¾” and 1″ Doors | x3 ea. |
| F | M6x60 Bolt + Washer | x6 |
| G | Routed Door Guide | x2 |
| H | ST4.2×35 Screw | x4 |
| I | Anchor | x4 |
| J | 1.5mm Allen Key | x1 |
| K | Hole Cover | x4 |
| L | 48″ Rail | x1 |
PLEASE NOTE: The installation manual is a suggested guideline. Adjustments may
need to be made based on your specific application.
Architectural Products by Outwater assumes no liability for improper
installation.
UNDERSTANDING YOUR RAIL
INSTALLATION
Using a pencil, mark
the locations where you will drill holes as indicated.
Before
beginning installation, attach the door stops [C] to the rail [L]. 
Using a power drill
with a 4mm drill bit, drill holes as indicated.
Architectural Products by Outwater assumes no liability for improper
installation.
Install the rail, and mounting brackets [E].
Drill holes into the doors as indicated. Attach the door rollers [A].
It is suggested that the door rollers [A] be mounted 5″ from the edge of the
doors to the neck of the rollers.
NOTE: Trimming the rail will alter the position of the roller hardware.
Adjust accordingly.
FOR ¾” DOORS
FOR 1″ DOORS
Attach the doors to the rail [L] and lock the anti-
jump disks [B] into position. Doors should be routed beforehand if using the
routed door guides [G].
If
using the routed door guides [G], install them at this time.
Repeat steps 4-7 for additional door.
Use the hole covers [K] to give the rail a finished look.
The rail can be trimmed if necessary using a band saw or hacksaw. Use blades
suitable for iron or stainless steel depending on your rail.
NOTE: If you are trimming the rail, do so equally. Each rail can be
trimmed equally up to 2½” on both sides.
However; trimming will alter the position of the roller hardware. Adjust
accordingly.
Once cut, add the end caps [D] to the ends of the rail and secure with a set screw.
Architectural Products by Outwater assumes no liability for improper installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>