Foxwell Connection Tester User Guide
- June 8, 2024
- Foxwell
Table of Contents
QUICK START GUIDE
Shenzhen Foxwell Technology CO., LTD
Vehicle/Battery Connection
OBDII/EOBD Test
- Locate the data link connector (DLC) under the dash on the driver side of the vehicle.
- Plug the tester to the vehicle DLC with OBDII adapter.
- Switch the ignition key to the ON position.
- Choose OBDII/EOBD APP to start test.
Battery Test
If you are testing the battery inside a vehicle, make sure all accessory loads
are cut off, the key is not in the ON position and the doors are closed.
-
Connect the current clamp cable to the OBDII adapter of the scanner.
-
Clean the battery posts or side terminals.
-
Connect the red clamp to the positive (+) terminal and the black clamp to the negative (-) terminal.
-
When the tester is correctly connected, choose Battery App to start test.
Tester Descriptions
A. OBDII Cable
B. LCD Display
C. Green LED Display – indicates the engine system is working normally (all
monitors on the vehicles are active and performing their diagnostic testing),
and no DTCs are found.
D. Yellow LED Display – shows the tool finds a possible problem. Pending DTCs
exist or/and some of the vehicle’s emission monitors have not run their
diagnostic testing.
E. Red LED Display – indicates there are some problems in one or more of the
vehicle’s systems. In this case, the MIL lamp on the instrument panel is on.|
F. UP Key
G. DOWN Key
H. LEFT SCROLL KEY
I. RIGHT SCROLL KEY
J. One Click I/M Readiness Key – quick checks state emissions readiness and
drive cycle verification.
K. BACK Key
L. ENTER Key
M. Power Switch
N. HELP Key – accesses to the Help function.
O. USB Port
P. Battery Clamp Cable – connects with the device to perform battery testing
function.
---|---
Updating
- Do not disconnect the Tester from computer or power off the computer during the process of updating.
- No Registeration Required
- PC : Windows 7, Windows 8 and Windows 10 supported
The Upgrade Process
| Download the update tool NT Wonder and install it. | NT-WONDER |
|---|---|
| Enable NT Wonder and connect NT301 Plus to the computer with USB cable. |
Click Update online or Update offline to start update according to the
software version conditions.| Update online
An Update Finished message displays when the update is completed.| UPDATE
FINISHED
Retrieve I/M
To Print Test Results
The test results stored in the tester and can be printed through computer. Test data can only be imported to your computer through NT Wonder.
Contact Us
For service and support, please contact us.
| WebSite: | www.foxwelltech.us |
|---|---|
| E-mail: | amazonsupport@foxwelltech.com |
| Service Number: | +86 – 755 – 26697229 |
| Fax: | +86 – 755 – 26897226 |
Pictures illustrated here are for reference only and this Quick Start Guide is subject to change without prior notice. For more detailed operations, please refer to the User’s Manual.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>