aidapt VM948 Shaped Sock Aid Instruction Manual
- June 8, 2024
- Aidapt
Table of Contents
aidapt VM948 Shaped Sock Aid
INTRODUCTION
Thank you for deciding to purchase the Shaped Sock Aid from Aidapt. The Shaped Sock Aid is manufactured from the finest materials and components available. When used correctly it is designed to give many years of reliable trouble-free service.
BEFORE USE
- Carefully remove all packaging. Avoid using any knives of other sharp instruments as this may damage the surface of the product.
- Check the product for any visible damage If you see any damage or suspect a fault, do not use your product, but contact your supplier for support.
INTENDED USE
The Shaped Sock Aid makes putting on tights, socks or stockings easy.
INSTRUCTIONS FOR USE
Using the Shaped Sock Aid is simple, but does require a certain amount of dexterity:
- Simply fit the sock or stocking over the moulded shape of the Sock Aid
- Slide the foot through the middle of the sock/stocking which will be shaped around to make it easier to fit your foot into the dressing aid.
- Pull up using the strong, integral cord until the sock or stocking is comfortably positioned.
- Slip the dressing aid out of the top of the sock or stocking.
CLEANING
Clean your Shaped Sock Aid using a non-abrasive cleaner or mild detergent with a soft cloth. Abrasive cleaners e.g. AJAX and/ or abrasive cleaning pads may damage the product beyond repair and should not be used. Always ensure that you wipe dry the equipment after cleaning.
REISSUE
- If you reissue or are about to reissue this product, please thoroughly check all components for their safety.
- If in any doubt, please do not issue or use, but immediately contact your supplier for service support
CARE & MAINTENANCE
Please make a safety check of the product at regular intervals or if you have any concerns.
IMPORTANT INFORMATION
- The information given in this instruction booklet must not be taken as forming part of or establishing any contractual or other commitment by Aidapt Bathrooms Limited, Aidapt (Wales) Ltd or its agents or its subsidiaries and no warranty or representation concerning the information is given.
- Please exercise common sense and do not take any unnecessary risks when using this product; as the user you must accept liability for safety when using the product.
- Please do not hesitate to contact the person who issued this product to you or the manufacturer (detailed below) if you have any queries concerning the assembly/use of your product.
Aidapt Bathrooms Ltd, Lancots Lane, Sutton Oak, St Helens, WA9 3EX
Telephone: +44 (0) 1744 745 020
Fax : +44 (0) 1744 745 001
Web : www.aidapt.co.uk
Email: [email protected]
[email protected]
[email protected]