Minoston MP42T Outdoor Plug In Photocell Timer with Remote User Manual
- June 4, 2024
- Minoston
Table of Contents
Minoston MP42T Outdoor Plug In Photocell Timer with Remote
Specifications
- Ratings (Total both outlets)
- 125V, 60Hz, Max.15A GP
- 15A Resistive
- 1000W Incandescent
- 1000W Tungsten
- 1/3 HP
- TYPE 3R Enclosure
- Wireless Frequency: 433MHz Rainproof Remote Battery: CR2032 * 1
Manual/program button
- OFF – power OFF
- ON – power ON
- 2Hrs, 4Hrs, 6Hrs or 8Hrs – ON at dusk, OFF 2, 4, 6 or 8 hours later
- DUSK-DAWN – ON at dusk, OFF at dawn
WHAT’S IN THE BOX
- CR2032 Battery x 1
- Remote Control x 1
Notes:
The outlet is pre-programmed for immediate use, but the configuration can be
customized to meet your needs. To pair receiver to transmitter
- Plug the receiver outlet to a power outlet.
- Press and hold the ON/OFF button on the receiver outlet for 3 seconds and the LED indicator will start flashing slowly.
- Release the ON/OFF button on the receiver and press ON or OFF button on the transmitter to pair the transmitter to the receiver.
FCC warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
(2) This device must accept any interference received, including interference
that may cause undesired operation. changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION – PLEASE READ!
This device is intended for installation in accordance with the National Electric Code and local regulations in the United States, or the Canadian Electrical Code and local regulations in Canada. If you are unsure or uncomfortable about performing this installation consult a qualified electrician.
MEDICAL EQUIPMENT
Please DO NOT use this plug to control Medical or Life Support equipment.
This device should never be used to control the On/Off status of Medical
and/or Life Support equipment.
OTHER WARNINGS
Risk of Fire / Risk of Electrical Shock / Risk of Burns
IMPORTANT SAFETY INSTRUCTIONS
-
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
-
Read and follow all instructions that are on the product or provided with the product.
-
do not use an extension cord.
-
Reference the National Electrical Code, NFPA 70, specifically for the installation of wiring and clearances from power and lighting conductors.
-
Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
-
do not install or use within 10 feet of a pool
-
do not use in a bathroom
-
WARNING: Risk of Electric Shock.
When used outdoors, install only to a covered Class A GFCI-protected receptacle that is weatherproof with the power unit connected to the receptacle. If one is not provided, contact a qualified electrician for proper installation. Ensure that the power unit and cord do not interfere with completely closing the receptacle cover. -
WARNING: Risk of Electric Shock.
Mount the unit at a height greater than 1 foot from the ground surface -
WARNING:
Risk of Electric fire. install only to a receptacle protected by 20A branch circuit over current protection.
SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>