SHINING 3D AccuFab-D1s 3D Printer Installation Guide

SHINING 3D AccuFab-D1s 3D Printer

Installation Procedure

STEP 1 Unpacking

1. Remove steel clasps on the wooden case to open it. Cut the straps and open the inner box.

2. Open the cover, take out accessory box,resin tank x 2, power adaptor and power cable from fixing foam.
   Take out resin tanks and remove the protective films.

3. Take out the printer and remove PE bag. Open the chamber door, take out the fix foa 1m & .2

4. Take out build platform in the fix foam

STEP 2 Boot Printer

Plug in the power adaptor and connect it with power cable. Press the power button 4 the back, then press the power button 5 the front

STEP 3 Install the Printer
The build platform bracket will move up automatically after booting the printer. It is time to install the resin tank and the build platform.

Install the resin tank
Remove the protective film on the protection glass. Inset the resin tank into the card slot and push it to the end in the direction indicated in the figure. When the edges of the resin tank are inside at right angles, it means the resin tank is placed appropriately.

Install the build platform
Remove the protective film on the build platform. Open the handle and insert the build platform into the bracket in the direction indicated in the figure. Close the handle and lock the platform.

STEP 4 Add Material

Shake for 2 mins before pouring material into the resin tank to avoid sediment.
Note that the resin level should be between the indicator lines of minimum and maximum.

Note: You can also add resin during printing without pausing.

STEP 5 First Print
Please refer to the “AccuFab-D1s Quick Start Guide” in the flash drive. The flash drive can be used for data transmission later on.

Product Preview

Part List

1. Build Platform： Due to the test printing in the factory, the surface may have few scratches, which will not affect regular use.
2. Flash Drive： Flash drive contains Installer of AccuWare, Printer profile “*.sndev” , User Manual , Quick Start Guide and “Factory test reports”.
3. Angular Knife: Used to remove models from the platform after printing finished.
4. Putty Knife： Used to remove models from the platform after printing finished.
5. Scraper： Used to stir resin in the tank to avoid sediment.
6. Brush： Used to clean extra resin on the model.
7. Cleaning Box： Used to store parts or alcohol.
8. Cloth： Used to clean optical path including projector lens, protection glass and resin tank glass.
9. PET Card： Used to level the platform and remove the cured layer.

Document Download Center: https://www.shining3d.com/download- center/
Support Center: https://support.shining3ddental.com/en/support/solution

AMERICAS REGION
SHINING 3D Technology Inc.
P: +1415 259 4787
1740 César Chávez St. Unit D. San Francisco,
CA 94124, United States

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>