ITALERI 6592 British Crusader Mk. III m. Tank Crew Instruction Manual
- June 4, 2024
- ITALERI
Table of Contents
ITALERI 6592 British Crusader Mk. III m. Tank Crew
INTRODUCTION
Designed at the beginning of the Second World War, the Crusader was one of the most important British “Cruiser” tanks reaching a production of over 5,000 units. Equipped with Christie suspension with large diameter rolling wheels, the Crusader possessed remarkable driving skills on rough terrain. The first versions of Mk. I and Mk. II were armed with a 2 pdr cannon. later replaced by the more powerful 6 pdr cannon. in the Mk.III version. Lacking adequate armor against enemy fire, it was also very vulnerable to enemy mines and anti-tank guns, and its armament was often inadequate in front of similar German vehicles. However, when used in a coordinated way, they managed to achieve good results
ATTENTION-Useful advice!
STUDY THE INSTRUCTIONS CAREFULLY PRIOR TO ASSEMBLY. REMOVE PARTS FROM FRAME
WITH A SHARP KNIFE OR A PAIR OF SCissOR AND TRIM AWAY EXCESS PLASTIC. D0 NOT
PULL OL PARTS. ASSEMBLE THE PARTS IN NUMERICAL SEQUENCE. USE PLASTLC CEMENT
ONLY AND USE CEMENT SPARINGLY TO AVOID DAMAGING THE MODEL BLACK ARROWS
INDICATE PARTS TO BE GLUED TOGETHER. WHITE ARROWS INDICATE ON WHICH FRAME THE
PARTS MUST BE ASSEMBLED WITHOUT USING CEMENT. THESE LETTERS (A – B-C..)
INDICATE ON WHICH FRAME THE PARTS WILL BE FOUND. PAINT SMALL PARTS BEFORE
DETACHING THEM FROM FRAME. REMOVE PAINT WHERE PARTS ARE TO BE CEMENTED.
CROSSED-OUT PARTS MUST NOT BE USED.
SUGGESTED COLOURS **Choose version before assembly
**
HOW TO APPLY?
Direction for applying the decals: cut the required decals out of the sheet: dip the into a glass of clean water for about 20; position the decals on the kit, letting them slide from the paper. For a better adesion, press them by means of a clean rag
VERSION
VERSION A
VERSION B
VERSION C
