UniGuard GT06L 4G GPS Tracker User Manual

June 8, 2024
UniGuard

UniGuard GT06L 4G GPS Tracker User Manual
UniGuard GT06L 4G GPS Tracker

Features

  • Vehicle/scooter/motorcycle tracking
  • Real-time tracking by SMS/Platform/APP
  • Speeding alarm/Geo-fence alarm
  • Power Cut alarm with built-in battery
  • Vibration alarm
  • Ignition ON/OFF alarm
  • Disable fuel or electricity
  • Alarm speaker
  • Remote controller set arm/disarm
  • Movement alarm

Specs

Content Specs.
Dim. 894416mm
Network LTE/GSM/GPRS
Frequency LTE-FDD 131/B2/B3/B4/B5/B7/B8/B28/B66 GSM :850/900/1800/1900Mhz
Module & Chipset A7670SA+AT6558R
GPS channel 66
Tracking sensitivity -165dBm
Location accuracy <5 meters CEP
Time To First Fix(open sky) Cold status <35s Hot status         <1s
Working voltage 9-36VDC
GPRS Protocol Classl2, TCP/IP
Operating temp. -20°C to +70°C
Back up battery 200mAh /3.7V Li-Polymer battery
Standby & Working consumption 5mA-50mA
GSM / GPS antenna Built-in
G-Sensor Support
Ignition status detection Support
Micro USB interface Flash firmware/Configuration
Configuration Mode PC — USB/GPRS /SMS
Power interface 8 PIN(Power/ACC/Relay/Speaker /SOS)

Install SIM Card

Preparation: insert 4G SIM card with activated GPRS data; Make sure SIM card with full balance; If SIM card with PIN code, must remove it advance.

Device light description

Light Signal Flashing Always on
Red Power Battery low Charging
Green GSM signal flashes every 3s after connected server No GSM/LTE network
Blue GPS signal flashes 3 times per second if GPS located NO GPS signal

Installation

The device has built-in GSM and GPS antenna, make sure front side upward and there is no metal shielding.
Installation Instructions

Wires connection

Wires connection

Command List

Note: All Alarms only will be sent to admin Number

Command Function
apn123456 APN APNname APNpassword Set APN
adminip123456 www.gpspos.net 8000 Set IP Port
password123456 888888 Change password
smslink123456 google link
fix020s060m***n123456 Set upload interval
ANGLE123456 30 Set angle change upload interval
acc123456 ACC ON OFF alarm
noacc123456 Cancel ACC ON OFF alarm
acc123456 1 Activate ACC ON alarm via speaker
acc123456 0 Cancel ACC ON alarm via speaker
quickstop123456 fast cut fuel
noquickstop123456 Cut fuel based on speed less than 20km/h
stop123456 Cut fuel based on speed less than 20km/h
resume123456 resume fuel
arm123456 Set arm mode when ACC OFF
disarm123456 Cancel arm mode
silent123456 Silent mode(speaker no sound but SMS alarm)
move123456 0200 movement alarm(200meters)
nomove123456 Cancel movement alarm
vibrate123456 1 Activate vibrate alarm(alarm speaker beep 5s)
vibrate123456 0 Cancel vibrate alarm
sensitivity123456 1 Set vibrate level 1
sensitivity123456 2 Set vibrate level 2
sensitivity123456 3 Set vibrate level 3
sleep123456 on GSM/GPS sleep when vehicle stopping
sleep123456 off Cancel sleep mode
suppress123456 Activate GPS drifting control
nosuppress123456 Cancel GPS drifting control
check123456 Check device parameters
IPAPN123456 IP APN Check
reset123456 Reset device
KC123456 0 Cancel alarm
KC123456 1 GPRS alarm (default)
KC123456 2 GPRS+sms alarm
KC123456 3 GPRS+sms+call alarm
admin123456 15018500598 Set admin number
noadmin123456 15018500598 Delete admin number
begin123456 Back to factory settings

Function of Remote Controller (B optional

Button Function Description
ARM Press for 1 time, siren will beep 1 time
DISARM Press for 1 time, siren will beep 1 time
SOS Press for 1 time, tracker will send SOS alert to admin phone number.
Deterrence/c ar search Press for 1 when it is in arm state, siren will beep

all the time, press disarm button to quit.

Web platform GPS tracking software

Website: www.gpspos.net
Default IMEI as user name, password 123456.
Searching APP: Search GPSPOS at Appstore, Search POSGPS at Google Play

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals