VENTURE LIGHTING AP0010 High Bay Fixture User Manual

: June 8, 2024
: VENTURE LIGHTING

Table of Contents

Before You Begin
Upgrade Instructions
Reflector Installation
Pendant Mount Installation
Safety Cable Assembly
WARNING
Documents / Resources

AP0010 High Bay Fixture
User Manual

V ENTURE L IGHTING’S H IGH B AY F IXTURE 300W (120-277V INPUT)

Before You Begin

Read These Instructions Completely and Carefully

Upgrade Instructions

STEP 1: Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.
STEP 2: Remove the existing luminaire. Dispose of the lamp(s) and ballast(s) per local requirements.
STEP 3: Each fixture is supplied with a carabiner (1). Place the carabiner through the eyelet of the eyebolt (2) on top of the fixture. STEP 4: Attach the carabiner to a secure structure.
STEP 5: Connect the fixture input leads to the supply wire leads.
STEP 6: Each fixture is supplied with 1-10V DC dimming leads.

If dimming is not needed, nothing needs to be done.
NOTE: Do NOT connect the dimming leads together. This will cause the fixture to not operate as desired.
If dimming is desired:
a) Connect the “+” supply lead to the “+” connection lead on the fixture.
b) Connect the “-” supply lead to the “-” connection lead on the fixture.
NOTE: The polarity of the dimming leads is important.
Improper connection will cause the fixture to not operate as desired.

Wiring Diagram

VENTURE LIGHTING AP0010 High Bay Fixture - Figure 2

STEP 7: Loop the safety cable through the opening on the side of the fixture as shown. Attach the opposite end of the safety cable to a secure structure. (3)

VENTURE LIGHTING AP0010 High Bay Fixture - Figure 3 STEP 8: Power can now be restored to the fixture.

Reflector Installation

Remove 3 of the screws which hold down the lens (remove every other screw).
Place the reflector onto the fixture and secure to the fixture with the 3 longer screws supplied with the reflector.

Lens Installation

VENTURE LIGHTING AP0010 High Bay Fixture - Figure 5

Pendant Mount Installation

Remove the eyebolt from the fixture.
Secure the pendant bracket to the fixture using the hardware provided.
Insert the pendant connector into the pendant bracket and secure the pendant connector to the bracket with the hardware provided.
Screw in the appropriate threaded conduit fitting/pipe and secure with the locking screw.
Complete the installation of the assembled pendant fixture by following the installation instructions above.

Safety Cable Assembly

VENTURE LIGHTING AP0010 High Bay Fixture - Figure 7

WARNING

Risk of fire and electric shock

Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance. Contact a qualified electrician for installation.
Venture Lighting’s High Bay Fixture installation requires knowledge of luminaire electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Do not make or alter any open holes in a wiring enclosure or electrical component during installation.
Do not dismantle the fixture without Venture Lighting approval.
If the external flexable cable of the luminaire is damaged, it should only be replaced by the supplier, a service agent or a Venture Lighting approved qualified person.

CAUTION

Suitable for use in wet locations only.
Venture Lighting’s High Bay Fixture must be operated within an ambient fixture temperature range of -30° to 40°C.

http://www.venturelighting.com/

AP0010-C
800-451-2606
6675 Parkland Blvd., Suite 100
Solon, Ohio 44139 USA
E-mail: Venture_Lighting@VentureLighting.com
VentureLighting.com
© 2022 Venture Lighting International