HALL TECHNOLOGIES 200A 2-Port VGA Splitter with Stereo Audio and EDID Management User Manual

: June 4, 2024
: HALL TECHNOLOGIES

Table of Contents

Introduction
Features
Package Contents
Installation
Specifications
FCC RADIO FREQUENCY INTERFERENCE STATEMENT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HALL TECHNOLOGIES 200A 2-Port VGA Splitter with Stereo Audio and EDID Management User Manual

Introduction

The Model 200A is a 2-channel VGA distribution amplifier (splitter) with stereo audio and EDID routing and emulation capabilities.
The RGBHV (VGA) input video signal is terminated and amplified for driving each output. The 3.5mm audio input is ground isolated to prevent ground loop noise and hum and is also amplified for driving each output.

The EDID (Extended Display ID) data that the video source sees can be routed from the LCD connected to OUTPUT #1, or emulated using internal EDID memory in the splitter. A recessed 2-position switch is used to determine the EDID routing. The internal EDID is generic and designed to render an image on most displays (please see product webpage for EDID details). To change the internal EDID, additional EDID programmer hardware is required (Model USB-EDID-HD15)

Features

Uses 500 MHz video amplifiers for clear and crisp image
Splits both Video and Audio
Isolated audio input provides immunity to ground loop noise
EDID routing switch (internal or from downstream monitor)
Can be powered from VGA source (some sources may not provide power on their VGA output)
Includes power adapter
Compact sturdy metal case
Made in the USA

Package Contents

Splitter enclosure
Input cables (6ft VGA and 3.5mm Stereo audio)
Power adapter (6 vDC, 300mA)

Installation

Step 1 . Turn all the equipment off and disconnect all cables
Step 2 . Using the cables included, connect a video source to the video input, and audio source to the 3.5mm jack
Step 3 . Plug video OUTPUT 1 and 2 to LCD, projector, etc. and audio to powered speakers or other audio devices
Step 4 . Make sure the EDID SOURCE switch on the unit is set appropriately (default = OUTPUT 1)
Step 5 . Power up the LCDs and then the PC
Step 6 . If the green light on the box (close to PWR connector) is not on, the video source is not providing enough power to operate the unit. In this case attach the supplied power adapter to the unit.
Installation instruction

Specifications

Video

Connectors Input and Outputs: HD15 female
Coupling: DC
Max Signal Level: 1 v p-p
Bandwidth: DC to 500 MHz
Input impedance: 75 ohms on RGB, 5K ohms on H,V
Connectors Input and Outputs: 3.5mm (mini-stereo)
Coupling: AC,

Audio

Max Signal Level: 2 v p-p
Bandwidth: 10 Hz to 20 KHz
Input impedance: 5K ohms

Dimensions

Dimensions W x D x H: 4 ¼ x 2 ¾ x 1 ¼ inch

Temperature

Storage: – 40° to + 158°F (-40° to + 70°C)
Operating: + 32° to + 122°F (0° to + 50°C)

Power

6 vDC, 300mA

FCC RADIO FREQUENCY INTERFERENCE STATEMENT

This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. It has been designed to comply with the limits for a Class A computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules.
Icons