ikan S00PW447RX Elite Remote Control User Guide
- June 8, 2024
- ikan
Table of Contents
ikan S00PW447RX Elite Remote Control
Quick Start Guide
Thank you for purchasing the ELITE Remote – Bluetooth iPad teleprompter remote. Please follow these simple instructions to get started.
Downloading Compatible Apps
- Go to the App Store on your tablet
- Locate the search bar at the top right corner and key in the name of one of our compatible apps.
- Select the app and install it.
Inserting battery into ELITE Remote
- Remove the battery on the back of the remote
- Insert 2 AAA batteries into the battery compartment
- Re-install the battery cover
Troubleshooting
If you have any issues with the ELITE Remote, please call us at 1.713.272.8822 Monday through Friday 9:00 am to 6:00 pm CST. Or you can email us at support@ikancorp.com.
Syncing ELITE Remote to your iPad
- Go to the “Settings” app on your iPad
- Select the Bluetooth tab on the left side and confirm the Bluetooth option is on (switch will toggle green).
- Turn on the remote by inserting 2 AAA batteries into the battery compartment. A red light should blink momentarily on the front side of the remote.
- Press and the hold the “Rewind & Forward” button for 3 seconds to sync the remote. A blue light should blink momentarily on the front side of the remote.
- The words “Elite RC” should appear on your iPad. Select it.
- Once connection between the iPad and the remote has been established, the status message next to “Elite RC” should change to Connected.
Re-establishing connection with your iPad
Once you sync your iPad and Elite remote, your iPad will always remember the Elite Remote. To re-establish connection, simply turn on the remote, press any button, and wait a few seconds. The remote will automatically re-establish connection with your iPad.
Controlling your iPad with ELITE Remote
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received,
including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>