OPT7 LIGHTING 2018-2022 Jeep Wrangler JL & Gladiator JT Installation Guide
- June 8, 2024
- OPT7 LIGHTING
Table of Contents
LIGHTING 2018-2022 Jeep Wrangler JL & Gladiator JT
Installation Guide
2018-2022 Jeep Wrangler JL & Gladiator JT
LED SIDE MARKER
FOR 18-22 JEEP WRANGLER JL/GLADIATOR JT AMBER/WHITE
PRODUCT SPECFICATIONS
Voltage | 12V |
---|---|
Waterproof Rating | IP67 |
Shell Color | Silver Plated |
Shell Size | (L)9.84(W)5.31(H)0.57 inch |
Wire Length | 39.37± 0.5 inch |
Packaging Dimensions | (L)13(W)12.2(H)1.85 inch |
INSTALLATION
IMPORTANT: Please carefully check the product for any appearance or
functional defects before you start installation
STEP 1
First, you need to remove the fender from your vehicle by releasing the
bolts/fasteners inside the wheel well as shown in Figure 1. STEP 2
Use plastic removal tool to pry off the air vent cover as shown in Figure
2. STEP 3
Please thoroughly clean the painted surface around the air vent with isopropyl
alcohol ( rubbing alcohol ) to remove dust or residue that may inhibit tape
bonding as shown in Figure 3. STEP 4
Tear off the 3M tape on the back of the side marker lights and route the
electrical harness through the upper channel.
Next, simply snap it in and press gently to make sure it’s firmly in place as
shown in Figure 4. STEP 5
Now, please connect the electronic wiring harness of the side marker lights to
the factory wiring harness separately (Refer to wiring diagram below).
Then, Power-ON to test and make sure all signal functions are working
properly. STEP 6
Let’s repeat the same steps on the Passenger Side.
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>