Commercial Electric WCW1PC 1-Gang In-Use Cover User Manual
- June 8, 2024
- Commercial Electric
Table of Contents
1-GANG IN-USE COVER
User Manual
WCW1PC 1-Gang In-Use Cover
CAUTION: TURN POWER OFF
NOTE: Base should be installed on a smooth flat surface. To ensure a
weatherproof seal on irregular surfaces such as brick or cedar siding, a 1/4
inch bead of non-hardening silicone caulk (not included) must be placed
between the gasket and the mounting surface.
Mounting to Receptacle Box
|
---|---
| 
|
- Back out receptacle screws. Do not remove screws.
- Align screws with the holes on the base.
- Select the appropriate adapter (Duplex, GFCI or Toggle/Round).
- Snap the adapter on the base as shown (Duplex adapter shown as example).
- Tighten screws.
- Lid and cord port door are pre-installed in the vertical position. To install in the Horizontal position, remove the hinge pins by placing a screw driver into the central space on the back of the lid. Use the screwdriver as a lever to push each hinge pin out. Align the holes on the lid with the hinge holes on the base. Slide the horizontal hinge pins marked (2) until they snap in place. Pull out the side cord port door and snap into other side.
WARNING: Improper installation of any electrical device can cause serious injury or death.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>