audio-technica BP898 Omnidirectional Condenser Lavalier Microphone User Manual

audio-technica BP898 Omnidirectional Condenser Lavalier Microphone

Thank you for purchasing this product. Before using the product, read through the user manual to ensure that you will use the product correctly. Please keep this manual for future reference.

Safety precaution

BP898

BP899

Although this product was designed to be used safely, failing to use it correctly may result in an accident. To ensure safety, observe all warnings and cautions while using the product.

Cautions for the product

• Do not subject the product to strong impact to avoid malfunction.
• Do not disassemble, modify or attempt to repair the product.
• Do not handle the product with wet hands to avoid electric shock or injury.
• Do not store the product under direct sunlight, near heating devices or in a hot, humid or dusty place.

Notes on use

• Make sure to hold the plug when connecting and disconnecting the cable. The cable may become severed or an accident may occur if you pull on the cable itself.
• When using the cable, be careful not to twist it to prevent damage to the cable.
• When plugging the cable into the microphone and the connected device, check that the connector is facing in the correct direction before inserting it straight. Inserting the connector or plug diagonally may cause a malfunction.
• Be sure to slide the resonance cap as far as it will go onto the microphone so that it fits securely.
• Push the windscreen all the way onto the microphone so that it attaches securely to the microphone’s base.
• Remove the windscreen by pinching the plastic part at the base. If you pull only on the sponge part of the windscreen, the sponge part may be damaged.
• When removing the windscreen with the resonance cap installed, make sure the resonance cap is not left inside the windscreen.

Specifications

• 1 Products with power modules
• 1 Pascal = 10 dynes/cm2 = 10 microbars = 94 dB SPL
• For product improvement, the product is subject to modification without notice.

Product List

Output connector

Unterminated cable (sold separately) Specifications

Refer to the table below for connector pin assignments to connect with wireless transmitters developed by other manufacturers. Also note that a load resistance may be required. Contact the respective manufactures for the load resistance value recommendation.

Dimensions

Using the clothing clip base (BP898/BP899)

The figure is BP898.

Attaching the resonance cap (BP899

• To boost high frequencies and improve intelligibility, slide one of the resonance caps onto the microphone.
• Be sure to slide the resonance cap as far as it will go onto the microphone so that it fits securely.

Using by taping or securing the microphone to a person (BP899)

Attaching the windscreen (BP898/BP899)

• Push the windscreen all the way onto the microphone so that it attaches securely to the microphone’s base.
• Remove the windscreen by pinching the plastic part at the base. If you pull only on the sponge part of the windscreen, the sponge part may be damaged.
• When removing the windscreen with the resonance cap installed, make sure the resonance cap is not left inside the windscreen.

Polar pattern

Frequency response

References

• Global Support｜Audio-Technica Corporation オーディオテクニカ
• オーディオテクニカ
• Audio-Technica Corporation | Headphones, Microphones & Turntables | Audio-Technica
• オーディオテクニカ
• サポート総合（法人向け製品）｜株式会社オーディオテクニカ

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>