Littfinski DatenTechnik 000135 Switching Power Supply for Digital Booster DB-4 User Guide
- June 9, 2024
- Littfinski DatenTechnik
Table of Contents
Littfinski DatenTechnik 000135 Switching Power Supply for Digital Booster
DB-4
This product is not a toy! Not suitable for children under 14 years of age! The kit contains small parts, which should be kept away from children under 3 years of age! Improper use will imply danger of injuring due to sharp edges and tips! Please store this instruction carefully.
Introduction / Safety Information
You have purchased the Switching Power Supply for the DigitalBooster DB-4 for your digital model railway. The DB-4-PowerSupply is a high quality product which is supplied within the assortment of Littfinski DatenTechnik (LDT). We are wishing you having a good time using this product. The Power Supply comes with 24 month warranty.
- Please read the following instructions carefully. Warranty will expire due to damages caused by disregarding the operating instructions. LDT will also not be liable for any consequential damage caused by improper use or installation.
- We designed our devices for indoor use only.
- Attention: Please switch off your model railway by disconnecting the transformers and switching Power Supply from AC-current before starting any installation.
Connection to Mains
The DB-4-PowerSupply is suitable for the operation on mains voltage of 110 to 240 VAC and a frequency of 50 to 60 Hertz. Each DB-4-PowerSupply will be supplied together with a mains supply cable which has an Euro- and a small- device plug. Connect the small device plug to the suitable small device socket at the DB-4-PowerSupply.
Connection to the DigitalBooster DB-4
The DB-4-PowerSupply will be supplied together with several output plugs. Please select the plug 5.5X2.1mm. This plug has an outside diameter of 5.5mm and a bore diameter of 2.1mm. The negative pole is outside and the positive pole is inside. Now connect the output plug 5.5X2.1 to the socket of the output cable and then the output plug to the socket BU1 of the DigitalBooster DB-4, as shown at the following illustration.
Adjusting the Digital Voltage
Adjust the voltage selection switch of the output cable of the DB-4-PowerSupply by use of the attached key or a suitable screwdriver to a voltage between 15 and 24 Volt. This voltage corresponds to the digital voltage that the DigitalBooster DB-4 will supply to the rail.
Littfinski DatenTechnik (LDT)
15370 Fredersdorf / Germany Phone: +49 (0) 33439 / 867-0 Internet: www
.ldt-infocenter.com
Instruction for the Switched-Mode Power Supply MWA2103GS is Subject to
technical changes and errors. 09/2022 by LDT
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>