beko K54285EB Built-in Freezer Instruction Manual
- June 9, 2024
- Beko
Table of Contents
Installation instructions
K54285EB_K54275NEB / HEB – Sliding
K54285EB Built-in Freezer
If the subject parts are not included in the product you have purchased, then
it is valid for other models.
The back wall of the wooden cabinet must be left open completely to kitchen
wall in order to allow sufficient air circulation to cool down the condenser
unit for energy efficiency.
Note: screws for connecting top plastic part should not be screwed very
hard, because of moving the plastic part easily left or right
side.
Installation step for 7 : screws should not be fully tightened at this
stage.
Installation step for 10: screws must be unscrewed.
Adjustingthe legs
If your refrigeratoris unbalanced: You can balance your refrigeratorby turning
the legs of it as illustrated in the figure. The corner where the leg exists
is lowered when you turn in the direction of black arrow and raised when you
turn in the opposite direction. Taking help from someoneto slightly lift the
refrigerator will facilitate this process.
Installation step for 13_B: screws should not be fully tightened at this
stage.
Installation step for 14: screws should be fully tightened at this
stage.
Installation step for 15: screws should not be fully tightened at this
stage.
Installation step for 16: screws should be fully tightened at this
stage.
Note: Installation step for 21* – only for some
models.
Note: Installation step for 21* – only for some
models.
Note: Installation step for 6, 7, 13 and 19 – only for Italy
models.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>