Pestill PTPESTACREPA Multifunction Electrosonic Pest Repeller User Guide
- June 9, 2024
- Pestill
Table of Contents
PTPESTACREPA Multifunction Electrosonic Pest Repeller
User Guide
SAFETY & WARNINGS
Ensure to read all instructions and warnings in this user guide prior to first use. Retain this user guide for future reference.
- Avoid using the repeller in extremely humid environments.
- Unplug the repeller if it will not be used for an extended period.
- This repeller is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the repeller in a safe way by the person responsible for their safety, and understand the hazards involved.
OVERVIEW
OPERATION
Powering on/off
- Plug the power cord into a socket then turn on the socket. The three LEDs and light will illuminate whilst the repeller enters setup before being ready for use.
- To turn off the repeller, turn off the socket then unplug the power cord.
Notes:
- Ensure the socket is clear of any surrounding objects.
- It is recommended to operate the repeller away from objects and furniture as this decreases the effectiveness of the frequency waves.
Modes
This repeller features four modes:
- Electromagnetic – Emits electromagnetic waves in 25 second bursts over 35 second intervals. These waves primarily deter cockroaches and other insects.
- Air purification – Emits negatively charged ions that attach to dust and pollen in the air. This causes them to fall onto the floor and purify the air.
- Ultrasonic – Emits ultrasonic waves with frequencies ranging from 25–60KHz. These waves primarily deter rodents.
- All – Activates all modes to run simultaneously.
Selecting the mode
- Press the mode button and the repeller will operate in electromagnetic mode. The red LED will be illuminated.
- Press the mode button again to activate the air purification mode. The yellow LED will be illuminated.
- Press the mode button a third time to activate the ultrasonic mode. The green LED will be illuminated.
- Press the mode button a fourth time to activate all modes to run simultaneously. All LEDs will be illuminated in this mode.
Note:
The longer the repeller is used in a certain location, the better the
performance.
Need more information?
We hope that this user guide has given you the assistance needed for a simple
set-up.
For the most up-to-date guide for your product, as well as any additional
assistance you may require,
head online to help.kogan.com
kogan.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>