PESTILL PTSOLPRLERA Ultrasonic Solar Pest Repeller User Guide

PESTILL ULTRASONIC
SOLAR PEST REPELLER
PTSOLPRLERA
USER GUIDE

SAFETY & WARNINGS

Ensure to read all instructions and warnings in this user guide prior to first use. Retain this user guide for future reference.

• Avoid using this product in extremely humid environments.
• Unplug the product if it will not be used for an extended period.
• This product is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of this product in a safe way by the person responsible for their safety, and understand the hazards involved.
• The noise frequency of this unit is mostly above the normal human range of hearing (20Hz – 20kHz); however, some people may still be able to hear the lower range of the unit (13.5kHz – 20kHz). For this reason, please place the unit out of earshot of common areas.
• Do not install the device in areas where children or babies are present.
• This product is not a toy, keep away from children and only operate after thoroughly reading the instructions.

OVERVIEW

1. Hook hole
2. Solar panel
3. Ultrasonic speakers
4. PIR motion sensor
5. Flashing LED
6. Frequency adjust dial
7. Sensitivity adjust dial
8. Bracket
9. Mounting pole
10. Pole connector

INSTALLATION

1. Ensure the rechargeable batteries are securely installed in the battery compartment.
2. Install the device facing the direction that animals and pests will come from to have a better effect. Peel off the transparent protective coating on the top of the solar panel to ensure it can absorb sunlight efficiently and place where the solar panel on the top can get as long time sunshine as possible.
3. Do not cover the PIR motion sensor; this will stop the unit from responding accurately.
4. If you mount the unit in the ground, insert the pole into the ground. Leave the pole 12cm or more above the ground. Note: Do not hammer directly on the device as this may damage the unit. Dig a hole to install it instead.
5. The top of device has a hole for hanging, so the item can also be mounted on a wall as an alternative to mounting in the ground or placed directly on a flat surface.
6. The product can also be charged with a 5V DC adapter on continuous cloudy or rainy days without sunshine.

OPERATION

• Sensitivity Dial (Left): Adjust the sensitivity of the PIR motion sensor. Turn the knob clockwise to increase the sensitivity or detect-able distance (even small animals with little movements can activate the unit at the most sensitive position).
• Frequency Dial (Right): Frequency and mode control. Turn the knob clockwise to increase the frequency and switch the working modes as following:
  • 0: OFF.
  • 1: Repels animals such as mice, small rodents etc.
  • 2: Repels animals such as large dogs, foxes etc.
  • 3: Repels animals such as small dogs, cats, birds etc.
  • 4: Strong LED light to repel animals such as raccoons, boars, etc.
  • 5: Repel all animals with variable frequency and strong LED flashing.

Note: To change settings, you must always start from the OFF position and then go directly to the function you need, do not change between settings 1-5 directly.

CLEANING & CARE

• To clean the device, use a soft cloth dampened with mild soap and water.
• Do not use harsh chemicals or abrasive cleaning agents that may damage the device.

Battery protection

• If the rechargeable batteries in the product have not been in use for an extended period (more than 1 month), the battery’s power may be depleted. It is suggested to charge the batteries by using a USB cable to fully charge the batteries.
• If old batteries fully charge very quickly, this might mean they are at the end of their usage life so you may need to replace them.
• Please dispose of rechargeable batteries properly at a recycling centre for used electrical and electronic devices.

SPECIFICATIONS

Power supply: 3 rechargeable batteries (recharged via solar panel) or USB power adapter (5V/500mA)
Infrared sensor angle: 110 degrees
Frequency range: 13.5kHz-45.5kHz
Detection distance: up to 9.1m depending on animal size

Need more information?
We hope that this user guide has given you the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require, head online to help.kogan.com
kogan.com

References

• Kogan Help Centre

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>