GRADO 786GW100X Wireless Bluetooth Headphones Owner’s Manual
- June 9, 2024
- GRADO
Table of Contents
GRADO 786GW100X Wireless Bluetooth Headphones
In the Box
GW100x
USB cable ;
USB -C to USB-A
Story Sheet
Owner’s Guide
(the booklet you ‘re ho lding)
Overview
Power
Long Press: Power On/ Off
Battery Saver- If unpaired for 10 minutes, GW100x will power off.
Charging: Plug the provided USB-C cable into the charging port and connect the other end to a compatible USB port of a computer or wall charger
Connect
Long Press: From the off state press and hold until charging light
flashes blue and red.
On your device, navigate to settings and turn on Bluetooth.
After a few seconds, you will see “Grado GW100x”. Tap to pair.
When the paired device’s Bluetooth is turned off or out of range, the GW100x
can connect to a second device.
-•-Blue & Red: Ready to Pair
Phone/Voice
Short Press: Answer/ Hang Up
long Press: Reject Call
Double Press: Voice Assistan
Short Press: Increase Volume
Short Press. Decrease Volume
Music/ Volume
Short Press: Play/ Pause
Short Press: Increase Volume
Long Press: Next Song
Short Press: Decrease Volum.e
Long Press: Previous Song
Specifications
- Bluetooth Version: 5.2
- Batteiy: 46 hours*
- Charging Time: 2 hours
- Codec: aptX Adaptive, AAC SBC
- Frequency Response: 20Hz~20kHz
- Nominal Impedance: 38 ohms
- Mic Sensativity: 42dB+/-3dB
- Battery Capacity. 850mAh
- Working Distance: 10m
Methods of pairing to Bluetooth may vary depending on the specific device. Please refer to the device’s manual for further details.
- Battery life will vary depending on the listening volume and genre of music played.
Safety Notice &More
Please read this instruction booklet fully before using the headphones and
carging case.
Hold on to this booklet for future reference or for someone else that might
use these headphones. In the case of losing this booklet, it can be found on
the official Grado Labs website (gradolabs.com}.
Do not use where Bluetooth is prohibited.
Do not use if there is apparent damage to the headphones or batteries.
To protect your ears from permanent damage, be caustious of using the
headphones at high and max volumes.
Be wary of using any headphones in situations that need your full attention
and sense of hearing.
Avoid leaving the headphones in extreme temperatures. Be sure to keep them
clean and dry to avoid warping, stains, and permanent damage.
If misused or damaged, the battery can become compromised. In rare cases this
might lead to extreme heat, smoke, or fire. If you notice the battery is
damaged, immediately stop any usage.
Grado Labs cannot guarantee the headphones will continue working as intended
if serviced by a 3rd party, and will void the warranty. Please go through
Grado Labs for any service requests.
FCC
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc, used with permission.
Apple is the trademark of Apple Inc., registered in the U.S. and other
countries.
aptX is a trademark of Qualcomm Technologies International, Ltd., registered
in the United States and other countries, used with permission.
There may be other companies and names mentioned in this booklet that may be
trademarks or registered trademarks of their respective holders.
Grado is a registered trademark of Grado Labs, Inc.
©2022 Grado Labs. All Rights Reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>