GRADO GW100 Wireless Bluetooth Headphones Owner’s Manual
- June 5, 2024
- GRADO
Table of Contents
GRADO GW100 Wireless Bluetooth Headphones
In the Box
Overview
Power
- Long Press: Power On /Off
- Battery Saver: If unpaired for 10 minutes,
- GW100 will power off.
- Blue: Fully Charged
- Blue: Powered On
- Red: Charging
- Red: Low Battery
- Charging: Plug the provided USB-C cable into the charging port and connect the other end to a compatible USB port of a computer or wall charger.
Connect
- Long PresS: From the off state press and hold until charging light flashes blue and red. On your device, navigate to settings and turn on Bluetooth. After a few seconds, you will see “Grado GWiO0”. Tap to pair. When the paired device’s Bluetooth is turned off or out of range, the GWi00 can connect to a second device.
- Blue & Red: Ready to Pair
Phone/Voice
- Short Press: Answer / Hang Up Long Press: Reject Call Double Press: Voice Assistant
- Short Press: Increase Volume Short Press: Decrease Volume
Music/Volume
- Short Press: Play/ Pause
- Short Press: Increase Volume
- Long Press: Next Song
- Short Press: Decrease Volume
- Long Press: Previous Song
Specifications
- Bluetooth Version: 5.0
- Battery: 40 hours*
- Charging Time: 2 hours
- Codec: aptX, AAC, SBC
- Frequency Response: 20Hz-20kHz
- Nominal Impedance: 32 ohms
- Mic Sensitivity: 42dB+/-3dB
- Battery Capacity: 850mAh
- Working Distance: 1em
Methods of pairing to Bluetooth may vary depending on the specific device. Please refer to the device’s manual for further details. Battery life will vary depending on the listening volume and genre of music played.
Safety Notice &More
Please read this instruction booklet fully before using the headphones and carging case.
- Hold on to this booklet for future reference or for someone else that might use these headphones. In the case of losing this booklet, it can be found on the official Grado Labs website (gradolabs.com).
- Do not use where Bluetooth is prohibited.
- Do not use if there is apparent damage to the headphones or batteries.
- To protect your ears from permanent damage, be caustious of using the headphones at high and max volumes.
- Be wary of using any headphones in situations that need your full attention and sense of hearing.
- Avoid leaving the headphones in extreme temperatures. Be sure to keep them clean and dry to avoid warping, stains, and permanent damage.
- If misused or damaged, the battery can become compromised.
- In rare cases this might lead to extreme heat, smoke, or fire. If you notice the battery is damaged, immediately stop any usage. Grado Labs cannot guarantee the headphones will continue working as intended if serviced by a 3rd party, and will void the warranty. Please go through Grado Labs for any service requests.
FCC Statment
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) thiss device must accept any interference received, including interference that may cause undesired operation. The Bluetooth® word mark and owned by Bluetooth SIG, Inc, used with permission gos are registered trademarks Apple is the trademark of Apple Inc., registered in the U.S. and other countries. aptX is a trademark of Qualcomm Technologies International, Ltd., registered in the United States and other countries, used with permission. There may be other companies and names mentioned in this booklet that may be trademarks or registered trademarks of their respective holders. Grado is a registered trademark of Grado Labs, Inc. 2020 Grado Labs. AlI Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>